icon tubular control arm rebuild/refresh questions

So I got a smoking deal (or so I thought) on some icon tubular upper control arms for my 13 tundra, they were missing a couple pieces of the bushings, but I bought new ones from ICON on ebay for a decent price but now I noticed the dust boots are torn and I didnt get the washer kit with them.

Where can I get replacement boots?

Where can I get the washer kit? Do I need the washer kit? or is them OEM the same?

I currently have SPC arms installed, anything re-useable?

any help is appreciated

 

I also once got a deal on a set but after further research I became weary of potentially having to cut tie rods to get my alignment where I wanted. I opted not to install them and have been thinking SPC. Why do you want to swap them out?

https://www.tundras.com/threads/icon-suspension-alignment-issues.39393/

 

The reason I went tubular was for clearances. I am going to switch over to OEM rock warrior wheels and continue running 35” tires.

I do not want to run spacers on my wheels so a potential clearance issue is the UCA.

I have spoken with a few people running the same wheel and tire and all have said the same that tubular uca offer more clearance.

thanks for the link above. I was unaware of the icon issues

 

I understand that completely. I’m about done refinishing my set to go back on with used 295/70/17s for now

 

Awesome. You going to run spacers or you think you will clear the UCA with that tire?

 

I have a set of spacers inbound but I may try them without and save the spacers for when I get a larger tire.

 

So, long story short. I reached out to ICON and they are sending me grease fittings and a washer kit for only the cost of shipping.

I located new nylon lock nuts (I have extras if anyone needs some).

I will be installing soon

 

Just put on a set of Icon tubular with Delta Joints. No alignment issues at all.