Tundras live: Dumb Dad Jokes, Incorrect Opinions, and Relationship Advice.

Bulldozer.

 

Can you notch the vanity for the baseboard?

 

Another option to secure it would be how the did big TVs.

High on the vanity secure a string/cord with an anchor poiny. Low in the wall anchor a screw that the string runs down to and around, then back up to the anchor on the vanity. Kinda like a simple serpentine belt, and then adjust tension to keep the vanity from tipping.

 

Ponderment:

where do y’all buy your energy drinks?



I get cases from Sam’s or Costco

 

You’ll need to cut the baseboard, install it snug to the back. However, the top should also be level in every direction. To do that, you may need to shim the base, and then wrap it with shoe moulding, or caulking if it’s a small gap. That’s my suggestion.

 

Yes, this is the tool you need. Start slow, draw a guideline

 

I use mine a lot for sanding stuff.

 

Multi-tools are awesome! Wear earplugs though

 

Yuge Dewalt fan here. Previously Red. Black & yellow for the win. Love their XR goodies and 20/60V Flex batteries. XR Tough. I have that DCF impact and it's no joke. I'm finally getting ready to start building on my off grid property and ramping up all my tools to Dewalt and Klein.

 

Yep.

I use a box knife with a level to make the initial cut, that'll give you a great guide.

 

I can't buy them in bulk.

Usually just the gas station or grocery store when the mood strikes

 

Not sure what you are cutting but this might help?

https://youtu.be/68JEdbp2-2w?si=3kTF35gx0a11GuxX

 

It might be a little tough to cut your line on the baseboard with a box cutter, I missed that the molding is wavy.
Just go for it!
I would use your knife on top for the caulking

 

Hell, I used a chisel and hammer in the old days for this stuff..
Draw the line with a ruler, cut the board by chiseling it down, and then pry it out...

 

The beaver moon is rising. No joke

 

My favorite moon.......