1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

OBD 2 Pin Out and Zero Point Calibration

Discussion in 'Sequoia 1st Gen (2001-2007)' started by Dogman5687, Nov 8, 2024.

  1. Nov 8, 2024 at 1:21 AM
    #1
    Dogman5687

    #1
    Dogman5687 [OP] New Member

    Joined:
    Oct 1, 2024
    Member:
    #123715
    Messages:
    28
    Vehicle:
    2007 Seqouia SR5 2WD
    Hey all, I’m trying to do the zero point calibration on my 07 sequoia and was having a hard time finding an accurate Pinot diagram for the OBD 2 port. If anyone could point me in the right direction I would appreciate it.
     
    Dogman5687, Nov 8, 2024
    #1
  2. Nov 8, 2024 at 4:33 AM
    #2
    KNABORES

    #2
    KNABORES Sarcasm incoming

    Joined:
    Jan 1, 2020
    Member:
    #40572
    Messages:
    14,589
    Gender:
    Male
    Arkansas
    Vehicle:
    2000 Limited TRD AC 4X4 Thunder Grey 278k miles. *SOLD* 2019 Limited TRD CM 4x4
    Bilstein 5100's on the forbidden notch Husky HD rear leafs 16x8 Eagle Alloy 187's with 285/75/16 MagnaFlow 3" flow through Pioneer touchscreen with backup camera Full interior and dash LED conversion Trailer brake controller with 7 pin Bedliner coat bumpers & trim ARE Mpulse topper - Rhino Vortex rack
    IMG_1796.jpg
     
    KNABORES, Nov 8, 2024
    #2
    Dogman5687[OP] likes this.
  3. Nov 8, 2024 at 5:50 PM
    #3
    Dogman5687

    #3
    Dogman5687 [OP] New Member

    Joined:
    Oct 1, 2024
    Member:
    #123715
    Messages:
    28
    Vehicle:
    2007 Seqouia SR5 2WD
    thanks!
     
    Dogman5687, Nov 8, 2024
    #3
Register FREE to Reply!
To Top