Help Needed with this!

Hello. I ended up pruchasing a TRD pro grille for my 2022 tundra. Have a good idea how to remove the old grille and install this one but wiring is my kryptonite lol. Can never figure it out. This grille comes with the main 18inch light bar and 3 amber lights. The light bar has the 2 positive/negative wires and the amber lights and 3 connections all connected to a white/black/yellow ends. How would i go about wiring this to my fog light switch?

 

Would prefer wiring this to the fog lights rather than installing its own switch

 

Lots of videos on YouTube. Shouldn’t be hard to find.

 

Seen lots of videos but not any that show how to wire this setup. Hence why i posted in here

 

Best setup for the markers is into an add-a-fuse, to the passenger side fuse box. For the bar, I'd purchase a harness with a relay that adds more protection. I used this, but needed to add wire in order to reach the + terminal:

$15 Wiring Harness 1 Lead, Nirider 12V 40A Rocker Switch Relay Fuse Nylon Wiring Harness Kit for LED Light Bars Fog Lights Work Lights Driving Lights Offroad LED Pods Wire Kit for Truck UTV ATV Boat

Amazon.com: Wiring Harness 1 Lead, Nirider 12V 40A Rock Switch Relay Fuse Nylon Wiring Harness Kit for LED Light Bars Fog Lights Work Lights Driving Lights Offroad LED Pods Wire Kit for Truck UTV ATV Boat : Automotive

From there, follow this guy's directions and you'll be set: https://youtu.be/P3YOAMF9NsA?si=nSg6D-f-07iol-Dl

 

Thanks for this! Really appreciate it. Do i need any connections for the markers into the fuse box?

 

Nevermind. Had to google what an add-a-fuse was. I will definitely go with this setup. Thanks again!

 

No problem!

 

Ok got the new grille in and used an add-a-fuse for the lights. Seemed to be working fine until I started the truck and all my collison warning lights came on and the check engine light. Anyone know what I did wrong? Everything I disconnected during the grille install was reconnected

 

you used this space?

 

I tested that spot with a test light and it had constant power with the keys off. Found a video that said it should be tied into the ING fuse on the driver side panel. Disconnected it, disconnected the battery and it has cleared everything. Not sure what happened

 

Maybe there was an issue with my test light. Is this the space everyone uses for their grille lights?

 

Yah, and it’s recommended by all companies that sell kits and wiring harnesses.

 

Thanks again for your help. That was definitely the right location