WHAT HAVE YOU DONE TO YOUR 3RD GEN TUNDRA TODAY?

I added a strip of rubber to the cuts on the front bumper and replaced the 18” wheels for 20”s with Nitto Recon Grapplers

 

What exactly is going on in that front bumper section?

 

Celeste is now a working gal, officially:

 

Oh, cool.

 

I got word my Tundra might be here this coming week...I'll post photos when I get her . She's red and she will have 35s on her

 

Put some wheel chocks in front of those rear wheels! I would hate to feel what it's like to be run over by my truck.

 

Installed the front Dobinsons MRR's.

 

Installed a new Icon Stage 4 kit, 35” BFG KO2’s, and 17” Method 305’s.

 

Had some on the other side between rear wheels not in picture!

 

Heavy hauling day

 

De-badged the truck. Love the clean look.

 

Those exhaust extensions are killer. I haven't seen those from anyone before. Custom?

 

I installed these for my old 1200 to reduce the temperatures in the right pannier, and luckily it fit the 1250 just fine too. Easy to fit, and work well:

https://www.excelcyclewerkes.com/Products/

 

Took lots of pictures and posted a detailed thread in the build forum

 

tire size? any lift? looks very clean

 

Tire size:295/65R20

No lift yet, has a little rub when steering wheel at full lock.

 

Red wasn't my first choice but I couldn’t pass up on it back when I bought it haha

 

THAT"S the bumper I've been looking for. What's the manufacturer's web site. Where'd ya' get it. (Looks great and has the function I've been searching for.)

 

Pretty sure I bent the passenger bracket for the front aero spoiler running over debris from someone who does know how to secure their lumber.

No light or anything but can tell it’s a bit canted when tucked in but looks ok deployed. Hopefully just a simple bracket swap

 

I got it from a guy who said it was a Lil B’s Fabrication. After I installed it, the angle of the wings/sides were way off so I cut em off. I think it looks great too, lol. Much better than before the cut

 

Thanks

 

I’m getting bored and running out of things to do while I wait for my bumper and long travel kits. So, moving on from the BMS can to HPS.

 

Looks real nice. I've been eyeing their intake kit as well. What are the two rubber hoses in the foreground? And what is the wire laying across the catch can hoses - JB4?

 

Those hoses are for the other cans I have in-line between the crankcase and intake tubes. Those catch little to nothing, so I may remove those eventually.

correct on the JB4 wires.

 

Received a better built radio knob. Drive mode knob will be here later this week.

 

Where did you get that knob?

 

https://www.ajtdesign-llc.com/online-store/Radio-Knob-2022-Tundra-BLACK-p659099511

 

As the previous post listed, AJT Designs. $100 for the pair.