Is this the only screw protector for the Speedo?

Damn Toyotas and their cheap plastic speedos.

can’t find squat except for this . All I see on Amazon are the navigation protectors


At least this comes with the shifter section too. It’s already scratching .



this is the kit
https://www.toyotafreaks.com/products/toyota-tundra-screen-protech-kit?variant=49096114635025

 

Screen protech is legit , that’s what I have on the big screen and the digital gauge

Really good stuff

 

Did you order it from the same site ?

 

Ordered directly from Screen Protech.
https://*****************/collections/shop-toyota/products/toyota-tundra-screen-protech-kit

 

no, I got it right from them with a discount code

 

Ordered from their site . Thanks again guys

 

I had a pretty bad experience with screen protect. I would not recommend it at all. Didn’t fit properly, AC control section was total garage, they don’t respond much. They didn’t want to refund me either, they wanted me to send the installation accessories back for a partial refund. Ended up disputing with PayPal and got a full refund.

 

Lmao damn it bro too late now I ordered .

did you try a different kind ?

 

I got a glass spigen from Amazon. Works great anti glare and was easy to install. That is for the radio screen though. Haven’t found anything yet for the speedo.

 

See my thread on it…
https://www.tundras.com/threads/screen-protect.138995/#post-3509989

 

The screw protectors for my speedo are sold seperately & individually wrapped.

 

So weird couldn’t find jack squat on Amazon for the speedo, what gives

 

You could probably just make one from paint protection film.

 

It does take time to put the film on, easiest was the 14" multimedia screen just because there's nothing around it. When I did mine I removed the surround from the gauges so there was nothing getting in the way. When I first peeled the multimedia protector off the sheet it folded over onto itself and I almost threw it out. It stuck to itself and was almost impossible to separate. My advice is get a corner started and before pulling it off the sheet spray down the front a little. Start peeling it off the sheet and spray it as you pull it from the sheet. With both sides wet if it folds over on itself you'll be able to separate it from itself easily. Also stuff paper towels under whatever panel your doing to catch the dripping water. The more water you use the easier it will be, keep it wet.

 

Here’s a video of how it’s put in . Seems easy.

https://youtu.be/xnqD9yQ42DU?si=_N_G3GSGModRWzoq

 

Part 2

https://youtu.be/xnqD9yQ42DU?si=oC-x8WvhnqbMe6fS

 

Good luck my issue was fitment then customer support

 

Finished installing it weeks ago . The Speedo was a pain in the ass . Bubbles took almost two weeks to disappear . The infotainment was easy af . The shifter area forget it , I screwed that one up

 

This is how M&M candies should be packaged.