Newbie mods

Hey everyone!

happy to finally be a part of the community. I am about to pickup a new to me 2020 Toyota tundra platinum and am already planning some mods. I plan to swap the OEM rims and tires and having a hard time finding TRD wheels so am looking at 18” method 321 wheels and want to put some Toyo at3 285/65 R18 tires on them. Does anyone know what kind of poke I would have with this setup ? I don’t plan to lift the vehicle and am wondering if I will also have rubbing

 

Those wheels have +18 offset so you'll probably poke ~1" but you can use this figure out how much more poke you'll have from your current poke. As far as rubbing depends on the make of the tire you run; some run bigger some run smaller by +/- 1/2".

From the link below:
No Lift Kit
Max tire sizes are:

• 18″ rims: 285/65 R18 – 5/10ths taller and 4/10ths wider than factory. Trimming may be necessary.

https://www.tundras.com/threads/largest-tire-you-can-run-stock-for-all-generations.9762/

 

Welcome from LA (Lower Alabama)! Check out the Wheels and Tires forum:
https://www.tundras.com/forums/wheels-tires.18/

 

+25 is the key to success

 

Welcome from NY.

 

Welcome from North Florida!

 

Welcome from Nevada

 

welcome from pa.

 

as long as you do not exceed 12.5” width, 13” will rub the UCA at least with my billet UCA from Icon did. Once the alignment was adjusted the second time it barely touches now

 

Welcome from Ohio

 

Have exact tires. No rubbing at all

 

welcome from Colorado and South Dakota!

take a look at 275/70-18 too, they're a smidge taller and narrower and a few sheckles cheaper - that's what mine came with at stock suspension and they don't rub a bit

 

Welcome from somewhere between Sun Lakes, AZ and Montrose, CO