Tundra Leveling kit 2” or 1.75” or 1.5”

This looks great. I have a Sport as well and am considering the Westcott.

I gave them a call and they told me that I should order the TRD Offroad kit which will give me 2" of lift vs ordering the Sport kit because the ride will be much more harsh with the sport kit since it already sits 0.5" lower and has more preload to the spring.

But I read your other post where you stated you left the top part out to just get 2.25" of lift vs 3".
If you installed the entire kit to get 3" I'm sure the ride would be more harsh.

 

Following as I just got a 22 TRD SPORT also. I hate the front in .5” lower.

 

Trd offroad struts are cheap when you can find them. . Add a set off spacers from cornfed and good to go. . 1" kit if you want it absolutely level. 1/2 if you want to keep a little rake.

 

Ended up ordering the TRD Offroad kit for my Sport. Will give me 2" of lift in the front with better ride quality vs the Sport kit.

 

I'm about to get the fabtech 1.5" installed with 295/70/r18s on a '22 SR5 sport. I'll let yall know how it goes. Probably won't be full level, a little forward canter.

 

What level kit is the smoothest on the road? I just got a 24 platinum and really like the stock ride quality so I don't want to sacrifice too much.

 

I'll let you know how the fabtech goes next week. I'm expecting it to be smooth.

 

Going on Monday

Fuel Flux 18x9 +20mm
Yokohama Geolandar AT G015 295/70/r18
Fabtech lvl 1.5”

 

Only 50 miles so far, about to run 200 miles tomorrow but look is level to me with the fabtech 1.5” on a sport.

 

Do you have any rubbing with this setup?

 

2024 Tundra Platinum. 2” level on front. stock rims and 285/65/20.. I’ve measured it a few times different flat places and the front is just about 3/8” higher than the back.
I tow a cargo trailer for painting business and it rides a little lower in back then I’d like… I want to get a 1” pucks for the back. Reading up on it. Just made my account on here today

 

It does rub slightly on the drivers side at full lock. Passenger side is fine.

 

How is the ride so far?

 

I'm pretty happy with it. At 35 PSI it feels no different than stock - I run it a little higher while I'm on the road (50) and it's a bit rougher. It's still not full level but I don't mind it being a little nose down for aerodynamic purposes.

 

I was told Toyota is on am OEM "Hold" and not selling any kits at the moment... may I ask where you got yours?

 

Just installed my Fabtech 1.5" last night. Haven't taken any measurements yet but the front is a little higher than the rear. with the cap and the 75lbs of gear in the bed, I feel like I'll be putting a spacer in the rear if the front doesn't settle out. The ride is like stock and I did notice I lost 1-2 MPG's. Hopefully if I raise the rear a little that'll come back.

 

Rough country 1.75 level kit, glad I installed the rear. My front raised a lot more than 1.75.

 

Could you explain? What else did install besides the 1.75 inches from Rough Country? Is this before you added to the back or is this the final product? Kinda looks taller in the front here, but could be thw ground etc

 

Gorgeous... can you tell me what size wildpeaks those are?

 

Do they ride any different with the leveling kit ? I’d love to put 35” on when my 33’s are worn out