P2441 not in limp mode with hewitt kit installed

Had Error code p2440 and truck went into limp mode so i bought and had hewitt bypass ikit nstalled but now truck no longer goes into limp mode but check engine light is on with error code p2441..I clear it with ODB Reader but it comes back..can i continue to drive and not give a damn about the check engine light and code as long as its not in limp mode?or is there any harm to anything else by driving. Frustrated. light and code is very annoying though..Please help

 

Did you order the Add-On option which is the pressure sensors?

 

No..is that the problem?

 

The pressure sensors maybe bad. I went to the Hewitt website and it says there that the pressure sensor options will clear the codes. But contact them for sure. Sensors are $200 something a piece.

 

Did you install the block of plates?

Which Generation kit did you buy?