Easy slide stopped working

So the wife used my truck. Haven’t picked up second fob so she used mine. When she got home we went out to dinner. Unlocked the car and opened the door. Had to hit the 1 button and seat moved in to my seating position. Drove to dinner and turned off the truck. Steer wheel tilted up but seat did not go back. Looked at customized setting and tilt and easy slide is selected. Any ides? Should I relinquish fob maybe?

 

I think it gets confused easily. My single fob is not registered to my profile, only my phone is. I gave my fob to a friend to move the truck 5’. (Without my phone) When I left the truck asked me for my Pin twice then finally said connection succeeded. CarPlay came up and all seemed normal. Now my seat isn’t sliding back at shut down even though it is set to in the menu. (Just noticed today) Tomorrow I’ll try resetting everything to see if it goes back to normal.

 

Did you have a chance to check it out

 

Dropped in here wondering what an Easy Slide was. Is it a new bed slide of some sort? Maybe a fridge slide?

Nope, 3rd gen problems

 

Sorry, yes. Checked half retract setting was still there in Settings but I changed it to full retract instead and still no change. Then at next start I pushed the Mem1 seat setting after my phone had connected. I noticed the seat adjust a bit. Shut off the truck and the seat fully retracted. Working fine now. Must have been re-selecting Mem1 after a non profiled driver that did it.

PS- Also noted that the seat slides forward into position by just buckling your belt even before you touch the Start button. Appears to be going to the last used Mem position. I had never noticed this because I always buckle up after the truck is started.