What have you done to your 1st gen Tundra today?

Who?

 

The ass wipe with the micro ween that we all know. Every town has at least one

 

Oooh that guy. Ok yeah lol

 

Montana. Another of the free states.

 

Parked next to a 1GT squaw. Wheelbase is the same.

Normal to have a floor shifter for 4wheel??? @shifty` @empty_lord






It clearly has buttons too?!?!?!

 

What is the magical burping method y’all use after changing a radiator? I’ve worked on Toyota fork lifts and they use to have a bleeder off the water pump to help with this. Just changed mine and it sure doesn’t seem to be circulating any coolant into the block.

 

Yup

 

Got any ramps? Drive the front tires onto ramps, pop the radiator cap and run the truck for a little bit

 

Yeah, he lives next door to me.

 

Tape m80s to his house windows and set em off

 

No ramps but I’ve got a pretty good ditch

 

That'll probably work.

 

Keep the heat on full-blast too, so you don't get air trapped at the heater core etc.

 

Thanks for the tip. Unfortunately I got called out to work so the burping has been out on hold for a few hours.

 

Young Barney

 

That will be me in about an hour

 

Cheers

 

Lit cigarette taped to fuse... extended delay for getaway.... Allegedly.

 

Whelp. I got the steering wheel controls "working." LOL. I got them wired up same as another member mentioned here using the

$64 ASWC-1 Steering Wheel Control Interface

ASWC-1 interface and they are all kinds of whacky. None of them work as what they are labeled. I'll need to do some reprogramming somewhere. Lol. They are backlit green. Nice.

 

What'd the controls come out of? I take it Sienna, given the backlight color...

Is it only the right-hand that's not working properly, or is it left and right controls not working?

The controls themselves IIRC are simply resistive; Only sending signal across one or two wires, and modulating out a different impedance based on the button pressed.

$64 ASWC-1 Steering Wheel Control Interface

ASWC-1 will let you adjust what frequency does what ... but it usually automatically gets it right.

 

I ordered the buttons from AliExpress. The cover from the sienna I got on eBay. Neither side works properly.

 

Honestly, the issue may just be that you got the buttons from AliExpress. I hate to say that ...

Just for diagnostic purposes, do you want me to send you a spare set of well-used dark grey left-hand controls I have out of a 4Runner?

If I were you, I would remove the ribbon cable to test with only the left-hand controls and get back to basics, in case the bridge is causing interference.

You may need to read the

$64 ASWC-1 Steering Wheel Control Interface

ASWC-1 instructions to forcibly reset it, then give it a chance to re-learn using the standard learning process described when you RTFM.

 

I'll remove the airbag and disconnect the right hand side controls tomorrow and try again. That's what I get for buying Chinesium shit. Lol

 

Ok, and for real, I'm happy to send you this xtra set of controls I've got. No sweat off my back.

 

Let me see what happens tomo and I'll let you know Shifty.

 

Dude trying hard to clear out another 3" of space in the garage all on the slick. That's just shifty ' behavior.

 

Attic space is getting slim!

 

i think I read something about wife's patience getting slim. But FMLA is hella time to get caught up with life.