Lift kit

Just curious I got a 2020 tundra limited want to do 6” lift with install and 35s on 20s how much would all that run to buy and install ?

 

Kinda a loaded question. How do you want to achieve the lift? Going 6 inches also means geometry changes.

There is a full subforum solely for Suspension discussions. https://www.tundras.com/forums/suspension.19/

Also you don't need a 6 inch lift to fit 35s. Read first post in this thread https://www.tundras.com/threads/largest-tire-you-can-run-stock-for-all-generations.9762/

 

11 posts with 7 threads started.

Maybe try researching and searching a bit first.

To answer your questions, anywhere from $300 to $10000

 

Just recently finished the build you described. Roughly $7k.
Totally worth it. These trucks look real nice lifted. Ride is way better than stock.
The set up I did, with lift, wheel size, tire size & tire width did not require any cutting or modifications to fit the larger tires. Retained all mud flaps and have no rubbing or all the other things you hear about.

 

This is a 6 inch with 35x18. Not the most expensive but defiantly in the higher cost range due to "if you are going to do it, do it right the first time". This ran me about 7k. You do have to cut the frame in order to do a 6 inch. 4 and lower you do not so if you do a 6, you cannot go back. Would I do it again, hell yes I would

 

At most $10k with a coilover setup.

 

I had always heard a six inch lift requires cutting and even the post below yours states this.

 

Sorry, just the cutting of the cross member. I meant, no cutting anywhere else to run the larger wider tires, like body mounts, inner fender, bumper etc....