stock fog lights

what does the fog light dial 1-6 do for the fog lights? no clue it is a mechanical adjustment because i replaced one already. also it not listed in the manual.

 

Nothing. It is only for the headlights so that you can aim them down when you are hauling a heavy load.

 

You mean the dash dial? It's a headlight adjustment.

Nothing for the fogs

 

don"t get it when i redid my lenses and led lights the used the adjusters in the lenses body?

 

You should be able to do fog light adjustments manually with a Phillips screwdriver..

 

The fogs are manual adjustments.

 

234 you fogs are much newer version than the 2011s. i still don"t get the manual headlight leveling dial i must be thick?

 

Similar dial on non led fogs

 

That is a general fog light photo showing what the manual adjustment looks like. Your fogs are manual adjustment and in no way tied to the dial on the dash.

 

Put your truck facing a wall at night and turn the dial. You will see the headlight beams move.

 

At night pull up to a wall, or even your garage if you have one, about 25 feet away.
Turn the adjustment knob and watch the beams of your headlights raise and lower..

 

This 3 minute video should have been 1 minute long..
Starts at the important part..

You can even see the beam moving on the white vehicle off to the right..

https://youtu.be/nd1C51xvvek?t=113

 

i get it

i will but the nogin is still thick i did not have and extra wires other than the stock light harness. but i will try thank you.

 

thanks that is loud and clear because lat winter my headlights were much higher in the distance level . you made my day thank you.

 

No problem.
After my 2.5 front lift/level I had to turn mine down a couple of numbers, as I kept getting flashed by oncoming vehicles.

For me, the best way to adjust these is when you're at a stop light or sign and you have say a Camry-sized vehicle in front of you.
I adjust the top of my low beams just to where they are just below the bottom of the back window and just under their side mirrors..
Not very technical, but it works for me..

 

i just check them out with the video and worked perfect thanks.