1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

CB Shackles on my lowered truck

Discussion in 'Ekstrom Design' started by nags, Apr 21, 2022.

  1. Sep 11, 2022 at 6:20 PM
    #61
    M3Tundra-JK

    M3Tundra-JK New Member

    Joined:
    May 3, 2022
    Member:
    #77930
    Messages:
    2,726
    Gender:
    Male
    First Name:
    Scott
    Vehicle:
    2005 GX470
    @nags Do you remember if your SOS lowering shackles were on the very bottom of the four available holes? The instructions say to put it on the bottom one for CrewMax, but then the picture it uses only has three holes in the shackle and not four. When I put the rear on the ground, there was about 1.75" of space between the top of the air bags and the upper perch it's supposed to screw into. So thinking I may need to go down another notch or two in order to close that gap
     
  2. Sep 11, 2022 at 6:31 PM
    #62
    nags

    nags [OP] New Member

    Joined:
    Jun 3, 2021
    Member:
    #63829
    Messages:
    780
    Gender:
    Male
    Florida
    Vehicle:
    2008 SC RCSB w/ all the goodies.
    This was prior to swapping in the CB's.

    Screenshot_20220911-213118.jpg
     
  3. Sep 11, 2022 at 7:26 PM
    #63
    M3Tundra-JK

    M3Tundra-JK New Member

    Joined:
    May 3, 2022
    Member:
    #77930
    Messages:
    2,726
    Gender:
    Male
    First Name:
    Scott
    Vehicle:
    2005 GX470
    Ah ok cool, that helps a lot! I'll have to wait until the front is on the ground to see if it's at a level stance or not. And then measure to order the correct CB's. I may actually need the 3" cb shackles since I have the crewmax and you have the reg cab, which instructions do say to have it where your picture is
     
    nags[QUOTED][OP] likes this.
To Top