What have you done to your 2.5 gen Tundra today?

Wow! That looks great! Well done!

 

Thanks bud!

 

Stop it! All of these clean bumper setups here get me drooling.

 

Sorry if this has been answered but what switch blanks did you use for that 3 panel behind the shifter?

 

Tech Stream brake bleed this morning. After changing to extended brake lines the pedal felt soft. Motive bleeder made it a tad better, but it wasn't until I cycled the ABS pump that things firmed back up.

 

How’d you make the beauty ring itself black?

 

I bought the small Toyota switch blanks. They fit perfectly. Part # 5553906090c0

 

Someone backed in to my truck at the mall. No note of course

 

That sucks!

 

I sprayed it with SEM Trim black a while back when I did the rest of the interior.

 

That sucks. Can you ask mall security if they have anything on camera. Or file a police report and perhaps they can check if there is any video footage...

 

• Fumoto valve and aluminum filter housing installed during oil change
• CCM Cat Security installed
• Dechromed the center console
• Completed moving sub remote from Tech12 to center console, was previously near USB ports

 

In my experience it’s usually not worth all the effort lol. Probably just get it fixed without involving insurance

 

Scott’s classic quality brake and muffler in Bonney Lake. Never been there but they are part on the PNW Tundra FB group and many of them swear by it.

 

Not a damn thing other than look at it this morning. Got Covid last week and it’s knocking the heck out of me.

 

That sucks, sorry to hear

This picture reminds of a dog asking to go for a walk. Just sad puppy dog eyes

 

Struggling to get my plastic covers back in after installing my AMP power steps. I'm talking about the two plastic covers by the footwell, one that lays horizontally and hides wires an the other that goes move vertical under the dash.

Anyone have problems with this? Any videos or recommendations? They're just not snapping in like I'd expect them to.

 

I need to do mine before I bump up to 37s

 

If you are talking about the driver & passenger kick panels, make sure the white clips that slide into the panel slots have not stayed attached to the posts on the body. If they have, pry them off the posts and slide them back into the backside of the kick panel. Then install on the posts and the floor stud with the plastic nut.

 

Looks like they may have some wet weather game as well.

 

added N-FAB EpYx steps.

 

Acquired 35s YOKOHAMA GEOLANDAR G003 MT, and a tundra friend of mine also picked up his 37s KM3, comparison review in the making.

 

++ Leer 100XR Camper Shell.

 

That looks great!!!!

 

Bet you'll like the Windoors a lot. I love mine.

 

Got it aligned after installing Bilsteins and Roadmaster Active Suspension. The shop finished the alignment pretty quickly and said it wasnt too far off. Still glad I took it in for peace of mind though and knowing everything is within specs.

 

Oil change on the Tundra....1st one since replacing the plug with the Fumoto. Rotated tires on both the 4R and the Tundra, of course now the TPMS isn't reading the tire pressures.

 

You probably did it already but did you reset it?

 

I tried it but they haven't popped up yet.