C4 bumper complete

Front end complete ✅ first hybrid with a front end treatment, keeping the streak of firsts alive!

C4 Fabrication overland front bumper
Westcott Designs trd pro camera bracket
TRD pro grill
Baja Designs LP6, S8 40in, squadron pros x2
Smittybuilt x20 12k winch
Factor55 winch accessories

Next up is topper and decked system and once I forget how much work the front bumper is I’ll toss on the rear that’s sitting in the garage

 

Loving it…not sure how I feel yet on the upper bumper wraparound piece for myself though.

I am assuming there is an option with just the core bumper?

 

Can get it plane Jane, with a low bar, mid bar or full height. I drive through lots of deer country in Idaho and montana so more is better in my eyes

 

Oh ok…thanks.
Yes, given that situation it’s probably needed indeed.

 

Have you noticed any adverse effects on ride due to the additional weight up front? Assuming there is some compression of the springs also

 

Random question, but since you’re running a hybrid, how did you end up doing the switching setup on your lights? I’m looking at a switch pros, but since the 12v batt is in the cab, it’s complicating things a little bit.

 

Those antelope and deer in Idaho are no joke. Looks good!

 

When adventure motors installed my lift kit we accounted for the extra weight with heavier fox springs

I was the first one to put one in, so it was tricky. I mounted my control panel where the sdhq mount goes (wish I had waited, but too late now and needed it in).

I was going to buy a longer control panel to control box cable but they were out of stock so everything is in the under seat spot opposite of the battery. All wiring runs through the grommets under the front seats and into the floor lines/ kick panels and into the same area. Not the cleanest instal, but no one ever opens that area up. If I could redo it I would get the sdhq mount, get a longer cable, or use the harness that adventure motors just posted in their instagram

exactly, so necessary. Clipped one a few weeks ago on my way to montana and didn’t even scratch the powder coat- plastic bumper would have exploded

 

I can confirm. I tagged a doe with the front corner in Idaho two weeks ago - now I'm looking to add a steel bumper like yours!