3W Liners window module question

Couple of questions on the 3W module. Is the auto up and down only controlled from the driver's door switches? Also, my drivers side rear door doesn't go into auto up mode until the window is about 3/4 of the way up? Any ideas? Thanks.

 

George did you see his video?

https://youtu.be/JasNy3ewPIQ

 

I did. I'm just wondering if there is a recalibration or something for the rear window issue.

 

I'd reach out to him and ask.

 

I will. And I wonder why his back come down first before the front. Mine are the opposite lol.

 

It is only controlled by the driver's door.
Plus you can use your key fob, well allegedly.
My aftermarket key fob will lower if I get the sequence timing just right.
But I can usually get it to lower the windows with the Drone mobile app.
Key fob raises the windows every time I lock the doors.

I can't remember which windows go up first on a lock or down when I use the key fob..
It's been 218 days since I lasted locked it....

 

I have it installed in my 2020. Auto up only works from drivers side. If I hit auto down, driver, pass, r.pass and r.driver for some reason the pass stops. All windows will go auto up from bottom position. Truck turned off and all windows down, pressing the lock on remote brings all windows up.

 

I've had this installed for a while now.

Auto up/down only available from driver door switches. All other switches stay the same.

All windows can go auto up/down from any position, seems like there is an issue with the rear door.

I can't remember remember the order the windows come down but can check later if you want.

One press of the lock button will lock the doors and bring all windows up. If I want to lock without closing windows I do two locks in quick succession. (I wish it was a double lock press to close windows instead of a single. It's annoying hearing the windows try to close EVERY time I lock up)

Key fob activation works reliably for me with factor fob. It is a little more difficult to get timing right with after market (remote start) fob, I think because of the delay in the signal making it to the truck and through the remote starter.

Only the front or back window can go down auto at a time. If I start trying to put down the front passenger then while it's going down I try to auto down the rear passenger the front one will stop in it's tracks. I usually put the front two down, then hit the back two.

Overall very satisfied. Saved me from the rain a few times when I was able to close the windows from inside the office across the parking lot.

 

I think it's an intermittent issue or just how the switch if activated for that window. It's just the up position. Down is always fine. I just haven't messed with it yet.

 

^ This sums it up perfectly.
Remote control window descending: After the car is powered off and locked, press unlock-lock-unlock, the four windows will descend at the same time, which is convenient for heat dissipation.

I can get it to work one out of 25 times with my aftermarket remote.
I can get it to work 1 out of 10 times with my Drone mobile app.
I never tried the factory key fob.


Toyota Tundra Window Control Module (low) for driver side window only going down automatically – 3W Liners

 

When I installed this on my 2013 Double Cab, from the Driver door controller you could only do either the fronts or backs at one time. So if were opening/closing the rear windows you had to wait until the all the way up/down or where you manually stopped them before you tried to auto-up the fronts. You also had to be pretty specific on how fast you clicked the window buttons to active auto up/down.

Remote Window control - should work with the OEM FOB. But like a previous poster, I had a Viper remote start installed and only carried Viper FOB which did not work.


Would love to install on my current 2021...but its supposedly not compatible with the Limited that have auto controls on the passenger side too.

 

Can someone check what fuse they include to go to the battery? I lost track of it at some point and just tossed a 10amp in there and it blew on me today. Wondering what they ship it with.

Thanks!

 

20 Amp

 

It's a 20 amp..
Took 5 minutes to get the damn cover open...

 

Thanks guys! This is why I love this forum, 2 answers within 10 minutes. Going out to swap out to the correct size. Appreciate the help!