Light bar wiring advice

Need a little help with wiring my light bar! Thanks in advance! I’m using an Auxbeem 6 gang system and have everything mounted and wired correctly except for the last red wire that needs to be plugged into the fuse box. It says it needs to be plugged into the ACC fuse and I can’t figure out which one that is. I know there are two different boxes one in the engine bay and one by the driver side Kick panel in the cab. If anyone has any advice it would be appreciated thanks!

 

If the red wires in the cab, go to that fuse box. If the red wires on the main brain in the engine, go to ACC in the e-box there.

 

You can also run off the ignition fuse under the hood if needed. It will get power anytime the vehicle is on.

 

The red wire comes off the Auxbeam box in the engine bay and it’s only like a foot or two long. I’m just having a hard time finding the exact acc fuse

 

Take the ebox cover off, look at the diagram under the lid, it literally says ACC IRRC

 

Sorry, says IGN.

Get an add a fuse.

 

That's the one I use, get a micro fuse add a fuse off Amazon and run it there.

 

IGN should be fine, that the fuse I used with my SwitchPro. Just use a tap-a-fuse and put a 5 or 7amp fuse on the top. Just make sure you get the right tap a fuse, its the micro one, the smallest ones available.

 

jinx

 

Jinx, buy me some coke.

 

Which kind of coke?

 

The good kind, with real sugar….

 

Real sugar and not the booger sugar then, got it

 

Great thanks everyone!