1st Gen. Lunch Table - General Discussion

I had this exact thought. But didn't go find a good GIF for it.

 

What can I say, it’s a boring morning.

 

I don't think you'll have to worry about seeing that where you live.

I'd be willing to bet your town has an ordinance against lowering your vehicle more than 2 inches.

 

He might not, but I saw an NA Miata dragging the rockers down the road on lunch today.

Sometimes IN is a-ok.

 

at this point you have no excuse to not make your porsche drag rockers

 

I'll have to take another trip through Lawrence, MA sometime. Plenty of lowered Civics/Hondas with extreme camber wheels and a 2 foot wing on the back. I can't help but laugh every time I see them.

If they only got slightly cheaper wheels, they could pay to paint the ridiculous body kits/wings they add-on.

 

I've done the rocker-dragging life. I like it, but not with this car. Need to do it with something a little more disposable.

Be careful not to overestimate what they spend on those wheels. Most of the civic stantzlorts around here run reps that cost less than the tires on any of my 3 vehicles.

 

Sorry, only vid i could find is on fb, but my s10
blazer is so slow i rock it to pass the wind bubble from 18 wheelers.

 

I’m at the junkyard, @Tundra2



AC so no B pillar for @empty_lord but it is grey interior.

 

Grey interior is easy to find. It’s the rear cab stuff is what I need

 

Waiting at LaGuardia airport. Never been so happy for a vacation to end.

I feel like the mista mista lady.

 

Yep, @empty_lord , I left a “we like reg cab” calling card. A few parts still worth quoting.


The cherry one is a flood damage phantom grey. I think this is the tailgate for @Tundra2 if I can get my hands on it.

 

I live out in the country, anything flies out here. Cops are too busy with meth mouths to care.

 

Doubt you are still there, but I am currently hunting a 4wd center cluster. The tabs on mine are broken

 

I don't think anything in eastern MA is really country. You have to go west of Worchester to see any of that.

 

and yet a 30 minute ride on the train has you in bucolic Pelham.
that's the school with the towers.

 

Sometimes it takes a place like NYC to make you appreciate where you live now.

 

I can ask for prices. I left a list of 7 w my contact info. I may need a little better understanding of what specifically you are after? I’m not sure what their prices will look like.

if you’re after the center bezel, there are a fair bunch on eBay.

 

Yessir, that is what I am looking for. Needs to be 4wd, have no broken tabs, and a black one like this: https://www.ebay.com/itm/284660024139?ssPageName=STRK:MEBIDX:IT

 

Red hazard or black? Mine is black.

I didn’t get a close look at the bezels but they had a few which looked clean. I’ll follow up on that one

 

That is a good question, I cannot remember on the hazard and the truck is at a friends place right now. I'll take a look tomorrow.

 

It's an important question. Later 1GT had different button setup. Likewise, HVAC controls aren't very interchangeable even within the same year, so it'd need to be swapped over. Earlier models had a smaller, tighter cutout for the radio. The clock section has different cutouts depending whether you have a 2WD truck, a 4WD truck, or 4WD w/VSC (traction control) which adds a 3rd smaller button to the left of 4lo/hi buttons. Not sure if there were 2WD w/VSC though.

I've still got my empty 4WD non-VSC black console panel (emptied out) for the later-model and it's in near-mint shape but would require moving over buttons but I don't think it'll work for your year. I'll never go back to non-wood, so I'm basically just holding onto it in case someone here ends up needing it one day.

 

If there were trucks like that in yards around here they would be stripped clean in a week.

 

Red hazard switch is 2000 only as far as I know.

 

You just described my SHO. It sounds good while doing it though.

 

I was impressed with the number of trucks he had. 6-8 in total. They plan to get at least 2 or maybe 3 back on the road. No RC but a lot of AC with decent interior.

One had black plastic fender flares which I was super excited about until I saw the passenger side rear which was punctuated. Buzzkill. Oh well.

 

If it's the OEM style TRD fender flares you have to have the holes in the bed and front fenders for them to fit right anyway

 

@Tundra2 Weather Channel says its going to get wild real soon in your area! Stay safe

 

Am I the only one that pictures Noah drunk and naked in front of a twister throwing a bottle of Jack Daniel's into it and the bottle not hitting the ground?
@Tundra2