Cut my stock fog light plugs too close, how do I fix it?

Flipping my truck back to stock and tackling the bumper next. Found my fog lights and plugs and it looks like I cut the wiring super short- no chance of getting them buttoned back on. Can these be taken apart for new wiring, or do I need to call the dealership and order new ones?

 

Pretty sure they can be de-pinned and new pins/seals added to the ends of the existing wiring and snapped back in.

 

You shit outta luck...get new ones

 

^this…just de-pin and re-pin

 

Going off memory here, Im sure someone knows for sure but if the OE plugs are H11, then buy something like this off Amazon or wherever.

$8 iJDMTOY H11 H8 H9 Extension Wiring Harness Sockets Wires Compatible with High/Low Beam or Fog Lights Use

https://www.amazon.com/iJDMTOY-Exte...1+fog+wire&qid=1636591748&s=automotive&sr=1-5
Cut the wires further back on the new harness and solder it to the OEM harness you cut. If you were close I could knock it out in a few minutes with the parts.

 

This is the route if I can verify h11. No soldering the new parts, just simple waterproof crimps and done

 

Vleds.com shows the fog lights on your 2019 as H11, H8, H9 H16.

 

Hard to tell from the angle of the picture, but I believe this is the connector. Pins and anything else you need to repair it should be available here.

https://www.corsa-technic.com/item.php?item_id=1623&category_id=91

 

Previous owner of my truck cut one of the fog plugs completely off! I went with OEM from the dealership because I didn't want to run the risk of it melting it catching fire with a cheap one from Amazon or eBay. Dealer cost was about $65

 

these worked perfectly, thank you!