Turn signals out

Help needed...
The turn signals don't work on my 2010 4 6 Tundra.
The hazards work fine...I replaced the flasher still nothing ...AL The fuses are good bulbs as well. There does not appear to be any cut wires anywhere that I an see that would cause a short. Could it be the turn signal handle itself????

 

Is it all 4 corners? I think there is a relay in the engine compartment fuse box.

 

Welcome to the forum. Did you also check the fuse box under the dash? Little skinny one way up in there about 2" wide 4.5" long. Right above park brake.

 

All four corners not working

All fuzes are good

 

Rodent damages somewhere maybe?

 

Welcome from NY.

Maybe it's the switch/contacts on the steering column?

Good luck, let us know when you figure it out.

 

Me thinks you may have missed a blown fuse. I think a slow verification would be wise. If it were me, I would even swap them around, same amperage ratings of course, just to verify.

 

I have a new turn signal handle have to get new battery .
I will double check all fuses.
Thanks for your help...much appreciated