What have you done to your 2.5 gen Tundra today?

how on earth did you do this?

 

I like the Red door handles that you did...just plasti-dip or did you do a full paint on them?

 

Got that Pro grille installed today, with the Amazon garnish plate. “So far so good” I drove around the city for a couple of hours with no sensor error yet. Hopefully it’ll stay that way *crossing finger*

 

I trimmed a little but bolted the bed rails over them. There is some play and I can now see why they wanted them trimmed down. I might do it later, but I don't put fridges or four-wheelers in the back so I should be just fine.

 

I was thinking about buying bolts 1/4" longer and putting the rails right over the Bedrug.

 

First oil change since installing the RCI skid. Between that and the fumoto valve my list of tools for an oil change is down to a 5mm hex key and a 3/8” ratchet with extension.

 

Using my remote start system. I used the ground out when armed wire to trigger two au-93 omega windo roll up modules. I used two 528 T pulse timer relays ( by directed electronics) to extend a negative pulse to the factory arm/ disarm wire. A 10 second negative pulse on each of those wires will roll down windows and open sunroof. The other wire will roll them up and close sunroof. My truck is a 2015 crewmax limited. The SR5 will not have the option for the front windows/ sunroof. If you can put your key in the driver door and turn to unlock and hold for 10 seconds the windows will come down and sunroof open.

 

I used the negative output when armed ( from my remote start system)to trigger two AU-93 Omega two window roll up modules. One for the rear windows and one for the rear window. The front windows are rolled up and down by using a extended negative pulse on the factory arm/ disarm wire using a 528 T pulse timer relay ( by Directed electronics) this also closes and opens the sunroof. If I am correct the crewmax limited and up have the front window close open option. Put your key in drivers door, turn to unlock and if your windows roll down and sunroof comes open you have that option on your truck.

 

I would love to post a video of it in operation but I can’t figure out how to post videos on here.

 

You can't post a vid directly from this forum, you can use YouTube, Rumble etc., and then link it here. Would love to see the vid. Good luck.

 

Truck looks even more awesome than it already was.

 

Installed the oem power tailgate lock. No loud clunk!

 

275/70/18 wildpeaks

 

shame on you!!

 

Installed the TRD air filter.

 

Added some tailgate lettering

 

It’s actually 2 11x6 molle panels. I ordered 2 RMP panels from GreyMan Tactical

 

Thank you, brother!
Yours is coming along nicely as well.

 

Installed my hike-it x9 today. Wow! Wife was not amused when I chirped the tires after hauling ass down the road and had to take a right to not stomp in the brakes and flipping a bitch. Had to put it in ECO-1 to keep the looks at a minimum. Boosted my highway MPG up to 18 though!

Also pulled the front tow hooks off and painted them New Holland Red (pretty close to TRD). Waiting to dry for a third coat.

 

I did a full paint. So far they are holding up

 

Got the Toytec shackles in, Eibach shocks, and the KB Voodoo rack on. Also the Coachbuilder brake relocation brackets.

 

Nice work, mine is sitting in the box, I will tackle it next days off.

 

How are they compared to plat blacks ? ...needing new and going to go either trd blues, plat blacks again or some Eibachs/or Billy's. Would love some Pro's but the cost is uggg.

 

prinsu rack

 

Finally got the hood stamp put on and the lights smoked. Next up install the bumpershellz stay tuned

 

Is it the truck just leveled? And what’s the offset? I’m wanting to go to 295’s but worried I’ll need a BMC

 

Color matched bumper caps finally arrived!!

 

Well if by "plat blacks" you mean the OEM shocks on the Platinum, it's really hard to tell as I removed a 1" block and replaced with Toytec shackles set at 1.5" so the ride is MUCH better now. Intuitively, because of their valving etc.. I would say the Eibachs are better and a good portion of the ride improvement. I've ran Bilstein 5100s on the front and rear of 2 4Runners, and was really happy. However a T4R isnt a Tundra. YMMV

 

The bolts that come with the rails will work, but the BedRug has such dense foam it will still have play. It just depends on whether you can live with that.

 

Installed my transmission cooler yesterday. Thanks for an awesome kit and great instructions @chasenicholas93 . All together it took around 4 hours. It
was around 90 degrees here yesterday afternoon, I ran her hard, and never saw the pan temp get above 190.