How wide can you go?

I need help, I’m about to purchase a RC 6” lift kit. I wanna go wide on the rims 24x14. I know I would have to do some major cutting. Is 24x12 I better choice? Or should I go with a 8” lift kit and stay with the 24x14. Thanks in advance

 

There is someone on here that is low and wide. Maybe look him up for insight.... if I remember who he is I'll link his thread

 

Offset matters. I run 20x12 -44 with 305/50/20s and don’t rub on a level with bumper spacers.
Without knowing the offset of the wheel and the tire size you want to run this is a very open ended question.

 

I would think 24x12 would definitely work maybe a bit of trimming. I’m on 3.5 RC lift and 22x12 -51 35s.

 

Nothing like wanting rolling paint chippers.

 

R U sure you want to do this?

 

Nothing like personal preference and people enjoying their truck the way they want it.

 

Nothing like not knowing! I got 20k miles on this set up and my paint is perfectly fine. On the other hand my grill has a few chips. In your chip prevention experience how do I prevent that? Drive in reverse?

 

Don’t even stress it anything past 0 offset gets super hated on this forum.

 

Fender flares is usually the go to. You could try a PPF in key areas if flares aren't your thing.

 

Ok thanks