Rough country suspension lift

Hey y’all need some help for my 2016 tundra.

even after replacing my lifted struts I’m still getting the dreaded tundra lean. Does anyone have any recommendations for fixing this.

suspension set up is 6” rough country spindle with preloaded lifted struts

 

I used a dobinsons spacer. Worked for my lean.

https://www.dobinsonsdirect.com/pro...er-for-land-cruiser-200-series-tundra-sequoia

 

Any of those 1/4 inch spacers will work- Dobinsons, toytec has them and I am sure other vendors as well.

 

Coachbuilder has them as well

 

So you can stack shims on top of the lifted struts.

 

Yep

 

Thanks for input. I have contacted rough country several times and no response.

 

To achieve seven inch would you recommend two shims on driver and one passenger

 

Two on the driver side and one on the passenger. Then you are ready to roll.

 

appreciate it

 

With regard to Tundra lean, have any of you found that there is less lean with heavier springs? Aren't 6112s 600lbs? I have them on right now, and had to do 2 on the left and one 1 on the right for a .5 inch lean.

 

I have the RC 6" with a slight lean... I bought a $40 pair of 1/2" thick shims from Summit (1" lift), milled one down to 3/8 and installed them accordingly. Leveled her right out. Out back I have a 2" shackle with the Icon RXT Leafpacks. Looks level, even, and perfect.

 

Hey guys was looking around while bored at the office today and found these shims. They are 1/2” and provides 1” lift. Has anyone stacked two of these on one side and had Amy problems.

 

measure first. Not all Tundras have lean

 

Op, how's that6" Rough ride holding up? Is it the N3 or newest version Coilovers?? Pro's/ Cons? Nice tundra by the way!

 

It’s an inch lower with the lean