Suspension noise after lift

I recently lifted my 2021 tundra with a complete arb ome lift with 700 springs with a dv8 bumper with winch and now I have a squeak/creak/pop coming from my front passenger side. I've went over it twice and tightened every bolt I touched, removed the skid plate and the sway bar and it's still there. It happens when I turn the wheel all the way like when backing into my driveway. It also happens when I hit a speed bump it will make the noise with the wheels straight. I only hear it at low speeds. Any ideas? I've been reading for a while and cant find anything

 

Did you tighten the lower control arm bolts.

 

Cranked the shit outta them

 

What are you running for wheel and tire setup? What offset? What size lift? Still stock UCA's? Just trying to determine if you may have any rubbing issues on the body mount, the UCA's, back of the bumper, etc.

 

Ome 2.5 with 700 springs. SPC uca's, method nv305 with +24 offset, toyo mt 35x12.50r18, cab mount chop. Aftermarket bumper. Definitely not rubbing anywhere I believe

 

Did you put an impact gun on them? Reason I’m asking is cause I had a popping noising when turning my tires left or right after an alignment was done. Ended up being that.

 

Na big ass breaker bar lol

 

I had a Jeep that did that one time with 6 inch lift.....ended up being a bolt to long and was rubbing when going over speed bumps straight or when wheels were locked out

 

Anyone else have any ideas?

 

did you ever figure out the issue?