What have you done to your 2.5 gen Tundra today?

doing iron remover on it too? we get alot on both of our vehicles since we both work in and around the plants.

 

So its been a while since I have ordered anything for my MAN Truck, so I ordered a rack from Victory 4x4 the other day. I'm really excited to add it to my Tundra but the guy at Victory 4x4 told me it would take 4 to 6 weeks to get it. He was really friendly and you could tell he knows what he's talking about but that is going to seem like forever to wait. Anyways does anyone have one already and if so what's your thoughts on it?

 

RCI makes a similar rack with a bunch of fun accessories. They might have one made and in stock to ship.

https://rcimetalworks.com/product-category/toyota/tundra/07-20-tundra/

 

Just finished installing the ICS Fab dash mount. With ram mounts. Also wired up their optional USB charger to charge the phone and GPS without all the wires hanging down.





The other wire and plastic piece you see there is my Weboost cell signal amplifier. Finally got it mounted up as well.



I ran it down along the frame and up through the grommet under the carpet just behind the drivers seat.

 

Oh yes. It worked great too. Whatever was on there was caked pretty good and it was stripped away fairly easily with the IronX. I rode out Delta in the plant and something spooged all over the parking area I was in. Of course it could’ve been a mile away and still reached us. Winds were crazy considering it was the far SW quadrant of the storm. 230kv dipped 40 minutes from the end of the storm and caused a bunch of carnage.

 

which plant?

 

New Relation Race Wheels RR6-H wheels and 315/70R17 Cooper STT Pro's installed today
Got home and discount had them set a little high on PSI (48 warm) so I dropped them to 38 warm for now, will recheck when cold.

 

The French one on the Sabine.

 

Which sensors? Parking sensors just need holes to be popped into, so any bumper can work with those. If you mean the TSS sensors, any bumper that doesn't have a bar in front of your grille won't affect it. The bars only matter if they are directly in front of the sensor.

 

Installed BW flares. Tomorrow is masking day so that I can put the PPF behind them. Anyone know where I can get larger seals that go on the flares?

 

When you did this were you able to reuse the oem nut? When I installed mine I couldn’t get the oem nut to thread. The Toytec took right away! Not too worried about it, the OEM was a little beefier so I always lean towards trying to use those parts when possible!

 

How do you like the Weboost? Is it worth the money, I've been thinking of adding it to my truck.

 

I still have some shudder in mine. I haven't looked at it yet.

 

Complete brain fart. Yes haha

 

Long week over here

 

hopefully the week is closer to the end then the beginning?

 

Good ol cheneire. That place is already below sea level and subsiding lol

 

Getting there!

 

I have a bit to go but have been enjoying some homemade Limoncello in the evenings after work. It has improved the week a bit hahaha

 

I installed the one that was on my 2013. I moved the same lift over to the 2020. I'll have to look at the angle to see what it looks like.

 

Close. The other French one lol.

 

It's highly likely you put the carrier bearing back on upside down. The mounting flange is offset from the center by about a half inch.
Your carrier bearing should look like the one pictured. One hole in the bottom. If not, it's upside down. Unbolt it and rotate 180 degrees.

 

Just checked out your build thread! That's definitely the best I've seen yet! Incredible job man!