Need wheel and tire help!

New to the the forum and I appreciate all the help.I have a 07 crew max with a 2in leveling kit. I was wanting to replace my factory wheel with after market. I’m wanting to stay with the 18 wheel size. I was wanting a wider wheel and taller tire that wouldn’t require any modifications. I would like for the wheels to stick out at least 1in. My truck is silver so black or chrome?

 

I have a 2010 crewmax and just put a set of 20x10 kmc wheels with a 285 tires. Only mod was the leveling kit and have no issues...

 

What size leveling kit?

 

Welcome from NY.

Maybe this will help....

https://www.tundras.com/threads/official-tundra-wheel-and-tire-setups-pics-and-info.95/

 

Wild Bill its just a 2 inch leveling kit.

 

Yesterday Method 701’s with Yokohama Geolandar MT’s in a 295 70 18 installed. I have 6112’s at top setting.

 

I really like Todd and Steve’s set up. Thank you guys for helping.

 

Thanks from Ky

 

What is the width of your wheels?

 

What is your wheel width?

 

Wheel is 18x9 with +25 offset. Tire is outside of fender just over an inch

 

No spacer or trimming?

 

No spacer. Did what everyone else has been doing. Removed front and rear flaps and did some minor trimming to front plastic liner. I elongated the bolt holes on bottom of liner and pushed liner forward close to an inch. All good now

 

How do you like them 701s?

 

figured I may as well get in on this thread rather than create my own for a similar inquiry. I just put a 3" level on my 2007 reg cab long box and I'm about to order a new set of rims. its sitting on stock alloys with a fresh set of 275/70r18 Goodyear wrangler Duratracs which sit roughly flush with the fenders. I wasn't able to find specs on factory aluminum rims but I'm trying to figure out the back spacing/offset so I can plan for the new rims to allow the tires to run about an inch out from my fenders.. is it just a matter of +25 offset or are the factory rims not "actually" a 0 offset rim?

looking in particular at a set of fuel hostage iii d568 anthracites .. id appreciate any input from someone who knows more about this than I do. thanks

 

Thanks for all your help. Im going to run the same set up.

 

Pics just for reference. My 2008 has a 2" spacer and I'm running 275/70/18 Ridge Grapplers. The first pictures are from my Vision Warrior wheels, which were 18x8.5 and a +25mm offset. I recently replaced those with Methods because the Visions started peeling the clear coat on all 4 wheels, at under 2 years of being on the truck.

 

Wild Bill im not running any spacers other than the leveling kit. I havent trimmed anything. I changed the step bars bc it was close to catching the edge of the old ones i had on but thats it. 20x10 wheel with 285/55r20 tires

 

Does your wheels have a offset?