14 tundra headlight problem

Drivers side headlight, high and low beam won't work. Changed fuses and lights. I checked the relay as well. Turn signal and all other lights work perfect. What next????

 

Have you tried putting a volt meter on the driver and passenger side and setting what you're getting?

 

Not yet but I will let you know when I do

 

I just did. I have 4.5 v from center pin but nothing from other 2. Also, the white epoxy in tundra wiring harness is not hard. It's almost a gel. I'm pretty sure that is not normal. I have 18 v in fuse

 

Any mods or additions at all? Count nothing too small. Are you the original owner?

 

Yes. Original owner. I have a 3" leveling lift, had hids but drivers side went out. Had hids for almost 2 yrs. Figured it just burned out. Put plug and play LED LIGHTS in today and still didn't work. Checked everything and found epoxy turned to jelly on harness for some reason

 

Are you using a motocontrol?

 

I had HID’s that used a motocontrol off the battery which caused the problems you are having with the HID’s and now the LED’s.

I took out the motocontrol and bought a plug n play harness from @iHacker on here for my Toyota LED headlights. Problem solved.

 

I'm pretty sure that's dielectric grease, not epoxy that you are seeing.

 

I second the above comments

 

Thanks. I'll take out the hid control and try. I'll keep y'all updated

 

I took out the mono control and still led doesn't work on drivers side

 

Which headlights are you running

 

Plug and play

 

New headlights all together or just new bulbs in stock headlights

 

I had dealership test it. Turns out it was faulty LED. I already have a new one in thanks for your help