2018 crewmax storage

Looks awesome, how about you make a set for your good old buddy silv333?

 

The problem with that is that you would have to find a solution for the seat mounts they would get in the way a bit. I believe they travel the length of the seat.

 

Hello. Did this eliminate cutting holes in floor board?

 

You still have to cut into the carpet and foam

 

Here is the setup that I did a while back:


Drivers side is a 130pc tool kit, middle is a $10 tool organizer from home depot with random gear, top is a $7 Tupperware tote with my compressor and battery cables.

 

Has anyone used the Sparks storage? How does it compare to ESP?

 

Did you need to go 3 boards thick to fit the bins? Could a single board still work?

 

If you can find a single board that’s 1.5” then yes, a single board will work. When I did mine, I glued two 3/4” pieces of plywood together (couldn’t find a 1.5” piece big enough to do the job).

 

Im ordering mine up, gonna save $$ over the esp. More money for other mods

 

Good man. I don’t care for the ESP either, bins are too small. It’s not worth the money.

 

Do you know where I can get my hands on an already built tray to drop in?

 

Depends if you are asking for a custom built one or the manufactured ESP storage system

 

Something off the shelf....

 

Going on a year and a half and so far and still happy with them. Don't really feel like I'm missing out on anything by buying a over the counter drop in. If you have the ability I would highly recommend doing it yourself. Save some cash.

 

Most definitely I’m pretty sure I can figure it out but I’m lazy

 

How has this held up, Im about to break this project wide open

 

I left mine unpainted.

 

I did the same

 

I got down n dirty with this. Actually went smooth so far and im a novice wood guy. Total cost about $50. I will cut the truck carpet tomorrow and wrap the wood in black carpet. Im going to Raptor spray the bins this weekend. I used some misc scrap wood I had to cut costs and made it work.

 

Looking good dont forget to cut the carpet to size to fit in bins

 

Almost done, found out an initial razor blade cut then chiseling to the floor board made a very clean job. The first box wasnt as clean but the other two were perfect. My daughter helped get the job done. Now if the Post office goes back to work I can get my raptor liner to spray the pans.

 

Hi, did you use full size pans for the middle and left compartments? If so, why not in the right one also? Thanks in advance.

 

The pan sizes are posted in a previous comment you have to use a smaller one on the far side cause of the tire jack. Looks like Kanobi13 used bigger pans then mine. The seat brackets are also not all evenly spaced

 

You got it.

 

Thanks OP, I noticed YOUR pan sizes, I was actually wondering which sizes did @Kanobi13 use.

 

so question - does the Toyota under seat tray not fit in the 2018s? There's that slight gap between the rise in the floor and bottom of the back seats, and I just don't see how the OE tray would fit (although I like this solution).

 

There is no such thing as a Toyota OEM under seat tray for a 2018 Crewmax. Toyota only made under rear seat storage for the double cab.

 

ahhh - yes, I see that now (was in the small print on the TP site - the direct Toyota site was much more clear). Thanks!! I will definitely be following this solution