5.7 motor mounts

Another set shipped out today. I have 3 kits left in stock!

 

@Bonzen Thanks, they fit/look really nice.

 

Can't say I'm surprised haha! Glad it worked out, hopefully you dont have anymore issues!!

 

I may be interested in this for my 19 Tundra TRD Pro

 

Awesome let me know! I'll build you a set

 

Check out the Instagram page @solid_offroad for pictures and info.

DM me on here or thru Instagram to order!

 

It’s almost done, threw the whole kitchen sink at it. I’m positive there will be no more issues. Thanks again!

 

Sometimes you gotta throw the whole kitchen at it! Awesome man sounds good!

 

Would you share that? It may be what finally convinces many of us to lay down the funds. Gotta think of the labor cost to R&R....hmmm.

 

I wish I could! It was on someone's Instagram story...unfortunately i have no idea how to find it!

 

The install on the 5.7 is very easy. If u can do brakes you can do these. Takes about 2 hours.

 

Is there a rear motor mount? or is this only for the sides? sorry for the newbie question

 

Yes that's it pretty sure!

Its like... holy hell..and that's on the street! Imagine what its doing off road...slamming around wrecking the stock mounts and flexing the frame. And killing horsepower to the rear tires. The 5.7 is a torquey motor..it needs to be securely restrained to use it all!

 

These are for each side of the engine. The "rear" mount is actually the transmission mount. Once you replace the engine mounts, the tranny mount isnt much of factor, as long as it's in good shape!

 

Still have a few kits in stock, @Bonzen?

 

I believe he has one left. Try him on IG, he's a little more active there

 

Thanks, I'll be in a better position to decide once my tax returns come in

 

It's not

It's not terribly difficult. Just hard to reach the bolts. Need an engine hoist and special Toyota adapters to bolt to the engine block for the hoist. Four bolts each side on the engine block and two each side on the frame.

 

thanks for the vid - but that is Far from a big deal. ever seen a 4 banger move??

 

Most people that do this install (on all the different trucks) just use a floor jack and a block of wood to raise the engine slightly to change the mounts out. Ive never used an engine hoist but I'd assume it would make it easier. As far as the install, the 5.7 mounts are are easiest install I've seen/done so far of all the trucks.

 

Ordering my set soon. Been following for a bit.

 

Cant wait to toss em on. Thanks @Bonzen !!

 

Those things are beef cakes

 

No prob! Try not to smoke too much tire rubber!

 

.250" thick flanges on the engine block and frame perch plates, and .188" thick on everything else

 

what are the torque specs on the bolts?

 

Hey Ryan, just wondering when my mounts might arrive at Kyle's shop? I sent payment on the 1st. Don't get me wrong, I'm not worried about your integrity or anything, I know 5 guys who've ordered from you. I'm just trying to plan my trip out to Kyle's and getting everything lined up.
Thanks,
Warren

 

Dm'd you.

 

The cross bolt uses a 9/16" grade 8 with a nyock nut. I dont have a torque spec for it but the steel sleeve in the bushings is your limiter. You'll feel the "stop"

 

Thanks