Need some help

2016 double cab 4.6l I removed the center bench seat to build a sub console with some more cup holders and such. In the process....... I removed the yaw sensor and forgot that I tucked it under the seat for measurements. Long story short the sensor was loose and about when driving 10 min to work this morning. Traction control light and the ABS light are now on the dash. Any ideas on where to start ? Can I just rebolt the sensor and clear the codes with OBD port scanner ? Or will I need to do the whole 0point calibration. Hoping that’s not the case but maybe some have run into this issue. Thanks again

 

I’ll give that a try when I get back I think the zero calibration would be more of if it was a R&R but idk I coulda gave it a mild concussion driving to work this AM hahaha but currently I feel like I’m driving a mini van if you ever need a good cleaning that’s bench seat has a lot of room for crumbs haha

 

Had to do a double take to see if you were me. I am B. Clark as well and own a 2016 double cab. Not from PA by any chance, are you?

 

Hahahaha no sir, I make some trips up to PA occasionally but from VA

 

Welcome from NY.
Bolt it back and try disconnecting the battery for about 5 minutes. If the lights are still on you will have to clear the codes.

 

Sounds good I’ll give it a try