What have you done to your 2.5 gen Tundra today?

Tufskins red to match trd knob and Barcelona red exterior.

 

That looks great, love the TRD logo on the wheels!

 

Thank you! The wheels are Rock Warriors that usually look like this, so the caps are OEM for these wheels:

 

Me too, hopefully this weekend. I'll post pics when done.

 

That's some good cargo right there..

 

Put my Diamondback Cover on my 2020 TRD Pro. Couldn’t be happier with it.

 

Finally installed the OEM bed rail system and some RockyMounts for the bikes. Oh...and 5100s -> 5160s.

 

Man I’ve been look at one of these for a long time. Unfortunately in still use the bed for large loads from time to time

 

It’s very easy to remove if you need access to the whole bed. The initial install took me about an hour by myself, but that involves dialing in the locks which is what took the longest. I could probably easily remove the whole thing by myself in about ten minutes, and have it back on in 15 or so if I wanted.

 

I've removed mine a couple times and it's less than 10min to pull off even by myself. Love my DB.

 

I agree. I’ve R&R’ed mine by myself more than a handful of times this past year. Very easy to do.

 

I got rid of it.
Got one of these. 2020 CrewMax Pro!!

Kept the wheels and tires, of course.

 

Do you guys know if it’s possible to tighten the clamps down too much on the middle panel? I stopped well before I felt like it was hard to ratchet anymore because I felt like it was going to crush my bed rail or break my track system. It still feels secure, but I definitely feel like I could have cranked down much more.

 

Nice.

 

Installed new front 2019 TRD sway bar Wednesday, same size as factory but 30lbs not 10lbs (approximately) eliminates sloppy feel, most noticeable improvement I’ve made to truck.

 

Yeah it’s possible to over tighten. Make sure you check again after about 500miles to tighten those bolts again.

 

I took the truck to my brothers garage and we went to work installing the Transfer Flow 46 Gallon Midship Fuel Tank.

Dropping the OEM tank



Here it is in all its pathetic'ness. I dont know how this POS made it on to our trucks



While my bro dropped the OEM tank, I prepared the Transfer Flow.



This is a two man job. It took the both of us, with the help of a floor jack to position and connect the Transfer Flow.

I put 20 gallons in to get home, and it didnt even reach half a tank. 20 gallons would have registered a full tank on the OEM.

 

I see you have the same fitment issue with the front driver side. I might have to remove mine in a few months and shave off a little to make if more flush to the black trim.

 

Installed APS side armor running board.



Wrapping the steering wheels with leather was an epic fail. I should had take the whole steering wheel apart. Or just buy a leather steering wheel off the bat. :-(

 

If you tighten the middle down too much, it makes it harder to adjust and close the end pieces. Mine’s not tightened down too much at all.

 

I really like those side rails. Who makes them? thx

 

Mine is definitely just snug, I have pieces of tape over the threads to keep them from backing off. I went too tight originally and you could see the bow in the 3 pieces how the center was tighter than the ends, so it's now loosened off to be flat from end to end.

 

Installed my FyreFlys LED kit for the interior lights. Much better than factory!!

 

Got the Genuine Neoprene Cover Kings installed..love my stock seats on my 2020 Platinum but I also have 2 kids, who love to spill shit...lol...gotta say I’m pretty impressed with the fitment and quality...the blue matches my boat scheme perfectly too

 

Replaced the chrome mirror caps with black plastic ones. Down to the door handles to replace.


Also installed the NSV dash cam. Wired it to the sunroof motor for constant power and ability to record when the truck is off. The screen flips up and the unit is 98% hidden behind the mirror when driving

 

Smittybilt.

 

Can you send details of this install

 

Installed Bora 1" spacers. I like the wheel stance of the TRD rims much better now.

 

Best $20 mod there is.