2019 Tundra TRD Pro TIRE SIZE

What is largest tires i can go on this stock 2019 Tundra TRD Pro?
What if I put a level kit up front for 1 1/2 inches and then what size could I go. Some guys telling me 34" will rub probably......... I would like at least 34 or 35.

Thanks

 

I think the TRD Pro is already leveled from the factory. If you go any higher in the front it would be nose high.

 

Welcome from Ohio!

 

Welcome from Nj.

I ran 275/70/18 on my 17 Pro with no major issues, before I changed the set up, just removed the small mud flap up front. Our trucks are already level from factory. As mentioned above, you will be very nose high if you install a shim up front without modifying the rear with something like shackles or a aftermarket leaf pack.

 

Its not leveled from the factory.

 

my front end is lower than the truck bed

 

WELCOME

 

Pros have very slight rake, I think I have read somewhere on the fourum some have been nose high. Being it is new, the aftermarket will take a while to catch up with parts. If it is a major issue for you, you can swap the stock coil overs and rear shocks for a different system. You can reach out to the below vendor for some help. Dave helped me when I wanted to change my truck up. There is a lot of knowledge on this fourum and great vendors. Call them and they will help.

Vendor: Ekstrom Design Sales & Questions: Coachbuilder1
Tel: (801) 635-4872

 

My 19 Pro came stock leveled. You might want to have yours checked out?

I run 285/70/18 with no modifications:

 

I'm running 315/70/17 on my Pro, which it is a 34.4 really meaty tire. All I had to do was some minor trimming and a BMC. Suspension is all stock.

 

I also have a 2019 Pro. The Pro trucks are about 1.5”-2.0” higher in the front than a standard Tundra. My truck may be just barely higher in the rear. I find it’s best to measure at the rocker as opposed to the fenders to see how far off you are. I am running 285/70r18 with no rubbing at all.

 

Every pro I have seen is level or very close. If you add more than a half inch up front it'll definitely be nose high.

 

I say 295/70/18

 

Welcome to the party!!

 

Pictures of the truck? All TRD pro‘s are pretty much level stock. If yours is not, there is either something wrong or you don’t actually have a TRD pro. You probably just have a TRD sport or off road.

Pics or

 

I'm no truck specialist but aren't the beds of all trucks slightly higher than the front end? Thats all I'm saying. I took it to four wheel parts and they said they would put a level kit on it and raise just the front about 1 1/2 inches and it would be good. I have a 2019 Tundra TRD PRO

 

If you add an inch and a half to what you already have it’s going to be nose high. You’ll need to address the rear after that. Be careful adding a spacer on top of your current suspension you going to need upper control arms most likely as well as extending your bump stops.

 

You do not want to put a 1.5” level kit on the front of your truck. You will be running way nose high and there are so many other reasons that you don’t want to do that because of ride quality and possible equipment failure. Other members will provide lot of details why this is not a good idea. ***Just looking out***

 

If this is a photo of your truck Bill Cohan, it doesn’t look like it’s a TRD Pro. The TRD Pro has that stamped into the side of the truck bed. I’m not seeing that when I zoom in on your photo.

 

It appears that what you have there is a TRD Sport rather than a TRD Pro. The TRD Sport is missing the bed stamp (see my picture above) and is not leveled.

EDIT: Although...I can't see your wheels in the lighting, they do not look like the stock TRD Sport wheels?

 

Without the bed stamp, that’s a TRD Sport with a 2019 TRD Pro grille. It’ll have factory rake. Rigid fogs?

 

Welcome !

 

Welcome from Texas

 

I'm wondering what the outcome of this thread is. The OP hasn't posted anything else. Do you have a TRD Pro or not? Is the front really lower than the rear? Did you get a level kit installed? So many questions and no answers.

 

No shit! I want to see a close-up picture of the bed stamp. A picture of the coil overs would be great too.

 

Not a TRD PRO but 35” tires Eibach front 2.5” lift shocks/coils and 1.5” front wheel spacers. Trimmed? Yes, no rubbing at all, rides excellent, running stock 18” wheels.

 

What size tires do you have? Is the PRO stock?