What have you done to your 2.5 gen Tundra today?

Mounted my front ADD Stealth Fighter bumper ...

Before ...


After ...


Next weekend, I get to try and mount the rear bumper.

 

I don't mind the holes and a bit of tape on the inside should keep any crap out.

 

Had a productive weekend and it's only half over...
New shoes, now the nannies don't kick in when I have to hit the gas to get out in to traffic. The PO had put some Firestone TransForce tires on and they only had a few hundred miles left. Plus needed something good in snow.

DIY bed rails, still need to paint them. The factory tundra cleats kinda fit, but not sure I can trust them.

 

Hello all, newbie here with a question. I have a 2019 Cement Off Road and installed a dual USB plug in the power port panel under the A/C controls yesterday in the blank cover spot. There's a wired connector installed in the dummy plug, no electrical connection and I'm trying to find out what that connector is supposed to do. I've searched the internet, these forums and...god help me...even looked in the owners manual, only to be shown that blank cover. I suspect it's for some kind of option but does anyone here have a clue as to what that would be?

 

Cool looking bumper! Lean and mean!

 

It's for an optional glass break sensor with the factory alarm setup.

Edit: Welcome from AZ!

 

Cool, thanks for the reply. Now I don't feel guilty about just stuffing it back behind the plastic.

 

I agree. It looks better when there’s more light.

 

Looks awesome. Looking forward to seeing pics of the rear bumper.

 

Took mine for its first oil change today, just a tad early at 4600 miles. Tomorrow it will be installing my AJT Designs vent rings which are due to arrive.

 

New cabin air filter.

And finally decided on an exhaust tip

 

Nice! I just got my Tundra yesterday and want some wheels. Are those stock 18”s? I don’t really want to lift my truck.

 

Converted my 2 way CDT component set to a 3 way by adding a new crossover and 3” midrange to replace dash speaker.

 

Yes. They were the stock 18’s.

 

What size wheels and tires? Is she lifted?

 

Stubby antenna!

Antennamastrus.com

6 3/4”

 

I forgot to add the box for the JL XD1000 amp and the LC6i. I want to keep the factory head unit.

 

Thanks and will post pics of the rear asap.

 

Stock Pros are 2 inch lifted at the front vs. Non-Pros.
Pro wheels are 18 inch BBS forged wrapped with 275/65/18 which is on the thin/small size IMO.

 

Took some photos of the projector light output this morning when o pulled into the office. The building is 55 feet or so away from the fromt of my truck. I locked all the camera settings to be the same - i had the shutter speed locked at 1/200 sec, so the photos are darker than in person
Low beams only

Low beams and Baja Designs sport - wide cornering - gen 1 sport lights

High beams

 

Now you have no idea if your truck fit inside parking garage...

 

Took off the 295/70/18 Ridge Grapplers and went with 285/75/18 Cooper AT3 XLTs.

 

Replaced my SR5 plastic steering wheel with a nice (new to me) used leather one.

 

Nice. What wheel was that with the red stitching?

 

...and this is where @Roman chimes in and I have to work OT to pay the credit card bill.

 

Straight swap.

 

Thanks, I had given up!

 

Renewed the registration tonight - $87, plus the $7 the other day for the state inspection

 

Looking good. Any rubbing and suspension modifications?