1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Engine Bay Accessory Mount and Location

Discussion in 'General Tundra Discussion' started by bamelanc, Aug 30, 2019.

  1. Aug 30, 2019 at 4:03 PM
    #1
    bamelanc

    bamelanc [OP] New Member

    Joined:
    Aug 26, 2018
    Member:
    #18620
    Messages:
    94
    Gender:
    Male
    Orange, Texas
    Vehicle:
    2018 Magnetic Grey Platinum 4x4
    Addictive Desert Designs Stealth Fighter bumper w/ 40" Baja Designs Onyx6 arced dual control combo light bar and Smittybuilt X20 Comp 10k winch. Baja Designs S8 10" amber fog lights. sPod Control for lighting and compressor. ICON Stage 3 Suspension with tubular UCA set at 3". ICON Alloys Six Speed 17" machined/satin black wrapped in 285/75/17 Nitto Ridge Grapplers. TRD Performance Intake. TRD Cat Back Exhaust. LED Kit inside and out. ARB onboard compressor. Amp Research Power Step w/LED kit. Retrax XR Pro bedcover. Armadillo Bed Liner. Tint - 35/5/5 ceramic. Center Console Safe. Weather tech mats.
    Anyone seen an aftermarket accessory mount or have done one where they've installed something like a Bluesea fuseblock in the engine bay? Looking for some ideas where I can install dedicated power as my battery has enough things connected to the posts. Looking to clean up the wiring some.
     
    P-Factor likes this.
  2. Aug 30, 2019 at 4:09 PM
    #2
    P-Factor

    P-Factor New Member

    Joined:
    Feb 14, 2019
    Member:
    #26094
    Messages:
    1,043
    Gender:
    Male
    Vehicle:
    2018 Tundra Limited Double Cab
    TRD Sway Bar, TRD Exhaust, TRD Cold Air Intake
    Good post! I'm also looking for a place/accessory for mounting a 1500 watt inverter.
     
  3. Aug 31, 2019 at 8:21 AM
    #3
    Scuba

    Scuba Sober member

    Joined:
    Oct 13, 2018
    Member:
    #20508
    Messages:
    1,243
    Gender:
    Male
    Austin, Tx.
    Vehicle:
    2012 Texas Edition CM.
    Only one I’ve seen the fuse block was screwed down onto the OE fuse block lid.
    Looked like a decent solution to me.

    I have to admit I haven’t researched them though as I have no use for one.
     

Products Discussed in

To Top