Going up to 35's

Do you HAVE to do a body chop to fit 35's on? The only info I got was that trimming of the skid plate is necessary. I'm going up 3" with my new suspension and going to 18's with 35" Nitto Ridge Grapplers. I still don't understand wheel math by the way (off set,spacers,etc)

 

What's the offset of the 18's you want?

 

5.71 backspace and 18mm offset

 

I really don't know what I want, just what I'm getting. 18" XD Bully's. I just told the shop they need to be functional for off road and I don't want it to look like a go cart.

 

I think a +18mm offset with 35's on a 3 inch lift will fit without a body mount chop

 

You'll loose some inner fender plastic but that's about it

 

I’ve got 35s with +25mm and clear fine. I would think the +18mm should be good.

 

Cool. Thanks buddy. I wanted some Icon wheels but timeline wasn't good. Trying to get my truck finished before I leave for Colorado for 10 days.

 

I'm running the same setup...although 20's. May have to bend the factory POS skid plate ends to omit rubbing at full lock. I just removed mine. What part of Colorado you visiting?

 

We go every year and try to do something different. Usually wing it. Starting off in Ouray then work our way to CO Springs. Haven't figured out the inbetween yet.

 

Open to suggestions

 

You run into problems when you go into neg offsets.

 

I have a +18 offset on my wheels with 285/65/20’s on a 3” lift. Only had to trim the front wheel well piece behind the fog lights.

 

Not to thread-jack.....
I've read the what fits thread in the suspension forum, but looking for some clarification.

If I do the 6112 at 1.9 with a shim on driver side, and none on passenger side. Using stock OR 18' wheels, do you think I would be able to fit 295/70/18 toyo open country 2 ? Or would I need to do 2.5" in front?

 

I had to chop them with my setup. Also had to cut the liners and trim the skid plate. I did 35x12.50x20 with an 18 offset. Check out my build link in my signature.

 

I have 35” ridge grapplers on 18x9 +25 rims with a 3/1 leveling kit. All I had to do was trim skid plate and remove mud flaps! No BMC!

 

Nice! Getting the same tires and the XD bully's. Did you have to recalibrate speedo?

 

TBH, I’m not sure if the shop did or not