Leveling kit issue

Put a leveling kit on my 09. 3 up front and 2 in the rear. Now my traction control light and vcs off light are on. Is there a say to recalibrate the zero point calibration without taking it to the shop?

 

I just put a Zone kit on my truck, same as you describe above and did not have any issues. Maybe recheck your wiring to see if anything was pulled too tight or cut when you dropped your rear differential down.

 

It did it before I ever dropped the rear.

 

Check the front. I did the same thing to my truck when putting on the lift kit pulled and broke the abs wire that's where I would check first.

 

A leveling kit by itself would typically not cause that. It must be an unintentional indirect screw-up - maybe a wire got disconnected or pinched when working around the suspension. There are wires going to the wheels for the ABS for instance that could easily be damaged when working around it.

 

You can see where we just spliced it back. Been that way for 2 yrs .I have been thinking to order a new cable just have not got around to it.

 

Definitely check the wiring. I have a 3/2 and don't have any issues. What kit are you installing?

 

Check all the wheel speed sensors/wires, one of them will most likely be damaged.