Adj UCA

Well I was told today my truck could not be aligned. All I have is a 3.5” lift but they say the camber adjustments are maxed out. I’m going to another shop for a second opinion but will adjustable control arms correct the positive camber if its really maxed out?

 

This is a first time I've ever heard of a problem with SPC UCA's.

 

3.5 is a lot of angle on the arms...you might be maxed out

 

I probably have like a 4 inch lift and my spc aligned fine

 

i think OP asking if SPC will fix his issue. He is probably on stock UCAs

 

I think he’s saying that he has stock UCAs? And was looking at getting SPC UCAs

 

It’s the stock LCA and the rough country UCA. I was just curious if the SPC UCA’s would fix the problem with the positive camber.

 

Hm I led you got the UCAs with the lift kit then I’d bring it to another shop before u bought new UCAs

 

It’s going to another shop this week. I have the SPC’s on the way from Amazon ( lowest price I’ve found) so if they can’t fix the alignment I’ll have them here.

 

O, I see.

 

Aahhh I misread his post as well. I’ll bet the new uca helps a lot

 

Sorry guys for not explaining it right. Kinda frustrated. It’s has RC upper control arms now and they are saying my alignment adjustments are maxed out. So I’m dropping it off by another shop tomorrow. I’d they can’t do it then I’m using the SPC’s. Basiclly jusy wantung to be sure he SPC’s will correct the camber.

 

Worked for me.

 

Did you get them for the price I posted in your other thread?

 

Try another shop. Most alignment places don’t know how to adjust alignment if it isn’t stock components. I wound up bringing my lifted 18’ to a chassis and suspension shop to get my alignment fixed from the previous “shop”. The second place got my alignment perfect in my opinion and had no problem getting it to where it needs to be.

 

Remember, Make sure they didn’t strip the bolt and washer cranking on them.