1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

When ONLY opening driver rear door, interior dome light won’t come

Discussion in 'Lighting' started by Hchadb, Apr 3, 2022.

  1. Apr 3, 2022 at 5:51 PM
    #1
    Hchadb

    Hchadb [OP] New Member

    Joined:
    Jan 21, 2018
    Member:
    #12334
    Messages:
    4
    Gender:
    Male
    First Name:
    Chad
    Vehicle:
    2020 Tundra Crew Max Limited 2WD
    Running boards, bed cover, wireless cell charger in center console
    My dome light comes on when you open any of the 3 doors except the drivers side rear door, at which the dome light does not come on. The spring loaded button in door jam is not stuck and functions properly from what I can tell. Any suggestions?
     
  2. Apr 3, 2022 at 5:59 PM
    #2
    Do58

    Do58 New Member

    Joined:
    May 9, 2020
    Member:
    #46334
    Messages:
    299
    Gender:
    Male
    I wouldn’t say it “functions properly” being that it doesn’t and clearly an issue. Maybe remove the rear door pin switch that DOEsS work properly and install it on the bad side. This WILL eliminate the pin switch itself. If still happens improperly, then there is a break in the wire somewhere.
     
  3. Apr 4, 2022 at 6:33 AM
    #3
    Hchadb

    Hchadb [OP] New Member

    Joined:
    Jan 21, 2018
    Member:
    #12334
    Messages:
    4
    Gender:
    Male
    First Name:
    Chad
    Vehicle:
    2020 Tundra Crew Max Limited 2WD
    Running boards, bed cover, wireless cell charger in center console
    Thanks Do58, I should have said that the door pin pushes in and out under spring pressure (does not stick in one position or another). I will look into your suggestion.
     

Products Discussed in

To Top