1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

rack and pinion problems

Discussion in '1st Gen Tundras (2000-2006)' started by papadave, Jan 3, 2017.

  1. Jan 3, 2017 at 5:49 AM
    #1
    papadave

    papadave [OP] New Member

    Joined:
    Jan 2, 2017
    Member:
    #5779
    Messages:
    1
    Gender:
    Male
    First Name:
    David
    Vehicle:
    toyota tundra 2002
    rebuilt rack and pinion now it leaks out the end of the cylinder rods where tie rods screw on cant seem to find anyone who knows whats wrong or to do to fix it even the dealer
    02 tundra rebuilt rack and pinion now it is leaking out the hole in the end of cylinder rod s both sides where the tie rods screw on im stumped what causes this and how do I stop it old papadave
     
  2. Jan 3, 2017 at 6:08 AM
    #2
    trayday

    trayday New Member

    Joined:
    Apr 17, 2016
    Member:
    #3163
    Messages:
    725
    Gender:
    Male
    Oregon
    Vehicle:
    2015 limited CM 5.7
    7" BDS, ADS front and rear, Total Chaos UCA's, CB tie rods
    Sounds like the seals. If its recently rebuilt, could be covered under warranty. Do you have oversized tires?
     

Products Discussed in

To Top