1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

POWERSTEP WIRING FOR DRIVER FRONT

Discussion in '2.5 Gen Tundras (2014-2021)' started by 2015CM, Jan 31, 2023.

  1. Jan 31, 2023 at 1:28 PM
    #1
    2015CM

    2015CM [OP] New Member

    Joined:
    Jan 31, 2023
    Member:
    #91212
    Messages:
    1
    Gender:
    Male
    First Name:
    Ken
    Vehicle:
    2015 CM Limited 4WD
    6" lift, 35x12.5x20 Powerstep XL Powered tailgate lock 12K winch inside Warn Bumper
    The instruction booklet is WRONG, at least on my 2015. The booklet says to connect the blue AMP trigger wire to the blue wire in pin #15 in the bottom white 20-pin connector. It actually needs to be connected to the grayish wire on the opposite side of the blue wire, 2nd wire from the top. Top wire is yellow, next one is it.

    20230131_132411.jpg
    20230131_132453.jpg
     
  2. Feb 1, 2023 at 5:34 AM
    #2
    agrestic1

    agrestic1 New Member

    Joined:
    Apr 7, 2018
    Member:
    #14263
    Messages:
    313
    Gender:
    Male
    Vehicle:
    2016 CrewMax
    AMP Research PowerStep, AMP BedStep Bumper Step, BedRug Carpet Bed Mat, Bazooka Powered Subwoofer Tube
    I had the same issue on my 2016, and I told them about it.
    Did you find the color wire for the rear drivers door and where ? I got frustrated and left it not connected..
     

Products Discussed in

To Top