Lift kit is in!

Lift kit I ordered just came in. Went with the OME kit with the 2614 coils and SPC upper control arms. Hope to get installed within the next couple weeks. Once I do, will update this thread with pics.

 

Measurements from the ground pre-lift. First is of the front, second is of the rear.

 

If you are changing tires, you might want to measure from the center cap of the wheel.

 

Wheels and tires are staying for the time being.

 

If I'm right, I think you should always measure from center cap/hub to fender. Doing it this way is most accurate. If you measure from the ground to fender, then tire pressures/treads can affect it.

I could be wrong though

 

You are correct.

 

^^^^^ yep

 

Center cap/hub to bottom of finder.

 

I'm getting closer to pulling that trigger on the Boss kit lol. They are 15% off right now through Dec 2nd.

 

Here are the measurements from the center cap, pre-lift. Truck is a little dirty, just got back from the deer lease. Lift is being installed Wednesday.

Has anyone had any issues with the TSS junk after they have lifted it and can a Toyota dealer re-calibrate if needed?

 

Just got back from the shop with the truck. Here it is now.

 

Looks great

 

Great looking lift. Any pics of the front axle angle and did you get the leaf pack or did you go with rear shackles?

 

Dakar leafs in the rear and SPC Upper Control Arms

 

Awesome results on the lift. Approved by a Black tundra owner.

 

Thanks, I’ve been searching through the forum for OME setups; you’re looks great. I bought the truck with KYBs that I’m looking to replace. Do you have any feedback on overall ride on/off road?

 

I had a similar kit on my Tacoma, that’s why I went with it. It’s a lift it and forget it kit, which I like. It’s definitely a stiffer ride than stock, which I prefer. As for Offroad, the only thing I do is deer lease roads, which it handles just fine.

Trying to install coach builder bumper shims today to try to avoid running when I get new shoes for the truck.

 

You got 4” in the front?

 

Close to it, I was surprised. Went with the 614 coils just in case I decide to do an after market bumper that is less than 200lbs. That was the day after installation, so it hasn’t settled yet. Should be 3-3.5” inches once it settles.