Carven Exhaust

Im not sure if anyone here follows Carven Exhaust. They just came out with one for our Tundras.


I was wondering if anyone had bought one yet? If so what is your opinion on it?

 

For the curious, here is a linky-poo: https://www.carvenexhaust.com/cat-b...venexhaust-com-cat-back-kits-toyota-html.html

 

From what I’ve seen and heard so far, I like how it sounds. Curious to see HP and TQ numbers.

 

Im debating replacing my TRD duals with the Carven.

 

Sounds great.

 

Anything other than stock muffler, with stock exhaust manifolds, gains 3-10hp 10-20tq to the rear wheels over stock. It’s not possible to gain anymore than that.

And with the above set up, if you use anything bigger than 2 3/4” diameter tailpipe you lose a ton of low end torque.

 

Sounds nice.

 

Aaaaaaand knowledge has been dropped! BOOM!

 

@Rheywood456 has a Carven muffler on his sick 1st gen.

 

That hanger exhaust tool though

 

Are the pipe diameters (in and out of the muffler) for the Carven exhaust listed anywhere. I didn't see it.

 

I tried. Came up empty handed.

 

Someone said 2 5/8” before muffler and 3” after the muffler

 

This is what we'll find with most aftermarket exhaust systems because they're built with one of "the big 3" pushrod engines in mind and not our Tundra's engine design. If anyone needs that explained by an expert, call 1-760-877-4234 and ask for Keith

 

Love mine. Nice Deep tone at idle. No drone while cruising. But you hear it when you punch it!

 

Need a Group Buy for the forums...LOL

 

That actually sounds pretty good but still love my 8 inch BA muffler

 

I had super 10 for 2 years and thought moving on to carven r would get me a louder roar but I’m disappointed the it’s sounds same as the trd exhaust ! Now have to pay to go back to flowmaster!

 

I went with their full system last June. Very happy.