Airbag light after front camera install

Hello everyone, so I installed a front camera on my tundra and after I was finished the airbag light came on with a error code of B1615 front airbag circuit. I wired the camera through the grill and didn't mess with any wires. The impact sensor is slower than the camera wiring. I even tried changing the grounding wire but still the same, also if I reset it, the light still stays on

 

Did you clear the code and did that code return?

 

Yeah code comes back right away

 

try this... Disconnect battery for 2 mins... unplug and replug the front sensors back in. Reconnect battery wait 2 mins again. clear the code see if it comes back... DONT disconnect anything with airbags or sensors airbags with the battery still connected bad things can and will happen.

 

Is this the FRAC harness made by @TundraTex ?

 

The camera harness?

 

The impact sensors correct?

 

I’m assuming u removed ur stereo to connect it to it ? Did u make sure the airbag under the stereo got plugged in all the way?

 

Airbag module? I didn't mess with that

 

Yes, did he make it or did you get it elsewhere?

 

Ebay

 

Oh, okay. Sorry I can't help.

 

Did you resolve this?
I am having the same error

 

Nope, still haven't gone to the dealer.