1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

3D Printed climate control trim rings

Discussion in '2.5 Gen Tundras (2014-2021)' started by prerunnerseth, Feb 14, 2020.

  1. Feb 14, 2020 at 6:04 PM
    #1
    prerunnerseth

    prerunnerseth [OP] New Member

    Joined:
    May 15, 2017
    Member:
    #7723
    Messages:
    521
    Gender:
    Male
    Apex, NC
    Vehicle:
    2015 MGM Limited 4x4
    So, as usual I have no interest in selling these. I will however provide the files when I'm happy with the design. It doesnt fully snap in yet. Need to work on some alignment stuff. Also it took some work to finish the face to make it look decent. This was more an exercise in design than anything. If you want to be cheap it's probably better just to sand and paint the originals. I have the AJT rings coming and will use them when they come in.

    trim ring.jpg
    20200214_205547.jpg
    20200214_205554.jpg
    20200214_210004.jpg
     
    Danimal86 likes this.

Products Discussed in

To Top