07 Crew Max 5.7 4x4 limited Transmission and transfer case wiring

I think I paid 35999.99 with 11 miles on it on June 10, 2007. Loaded Silver. Grey Leather Kenwood stereo fobs still have both. 5.7 4x4 crew Cab TRD limited. Small bed. Now with 297320 miles its had its first will not move.
This comes from electrical tape. Yes, Tape. As the truck has grown with miles its also gained in Height. Wheels and lift kit. The tape was used when I replaced the accumulated for 4x4. Front transaxle, I changed the old tape used on the wiring protector on the connector ends. This is due to factory seal loss. That was in 2010.
I was in the yard moving a 35 ft lift. The traction o my steep yard required my need for 4 wd. It was then that I moved the Transmission into the drive. 3 ft forward and the interment panel lite up with all system malfunctions, any and all 4x4 transfer and transmission abs trac control/ Tape was wrapped around the front drive shaft and tore all wiring from those components out No connectors and all wire 2- 6 pin 3- 2 pin 2-4 pin. I can't read wiring diagrams. I can do the wiring splicing. And connect new pins after removing old ones. Did anyone get any pics? If they have changed an accumulator out before or transferred a case? That would cure my current connection issues Thanks to all

 

Wow, that is an interesting situation! There are folks on here who might can help, but I would post your question in the Ask the Toyota Mechanic thread to get started. Not everyone pays attention to the Intro forum.

Welcome from LA (Lower Alabama)!

https://www.tundras.com/threads/ask-the-toyota-mechanic.2404/

 

Welcome from Pennsylvania

 

Yea, I am going to add pics.

 

Welcome from So Cal