Help! Any input on what size wheels, lift, tires this truck has?

Folks, I'm new to the forum and have been doing a lot of research to change out the look on my 2014 Tundra. I found the picture of a Tundra that I'd like to replicate but unfortunately there is no information about it. I'm curious if any of you have enough experience to look at this and provide input on likely lift, tire size, etc. The more specifics the better. I'm looking for something very similar and love how clean this looks. Tires not sticking too far out beyond fender, wheel well filled out fairly well with tire. I'm looking for tires that are almost flush, maybe protruding half inch at most beyond top section of fender.

This may be like throwing darts but anyone care to guess how much lift, tire size/diameter/width. Appreciate any input!

Wheels appear to be XD825 - Gloss Black Milled - no clue on size, offset, etc.
Tires appear to be Nitto Trail Grapplers - no clue on size

John

 

Possibly a 3/1 kit

 

You can also check out customwheeloffset.com

 

My best guess, looks like a stock PRO on 33's with 18" wheels.

 

Looks like between 3-4” lift

34” tire MAYBE 35”

Could be 20” wheels
Look up the wheels in 20” or 18” and for tundras 5x150, and you’ll be able to see the offset it comes in. Never comes in more than 2 for a specific truck. Looks like a 18 offset to me ( or close to it)
Width of the tire could be 295 or 305.

 

Imo maybe a 4" lift not at all more then that but its hard to tell because their are no step bars it may just be a level kit with 33" tires .

 

Looks to me like 3/1 lift with 285 65 r20 tire. And wheels are between +30 and +25 offset. There are TONS of ways to achieve a 3/1 lift. Urinal cakes (aka spacer on coils) are not the preferred method.....IMO

 

Cool, thanks for the input fellas. I was thinking it looked more like a 20" tire and at least 34" tires. My current Tundra has a 3"1" lift with 33" tires and it doesn't seem to fill out the wheel wells like the tires in this picture does. I'll keep digging, maybe go down to a 4 wheel parts or something and get some of their opinions. It's funny how complex this stuff can become in trying to get exactly the look you want.

 

I looked up the wheel and this wheel only comes in a 20". Here is what I think this one is, looks like a 25 offset. Now I just have to figure out how large the tire, I'm guessing this has to be at least a 34".

PART NUMBER SIZE BOLT PATTERN OFFSET B/S FINISH BORE LOAD RATING
XD82529058325 20" x 9" 5x150.00 25 5.98 GLOSS BLACK MILLED 110.5 2700

 

Well, the tire is a Nitto Ridge Grappler, if that helps.

 

831Tun, thanks. If I can just figure out if it's a 33, 34 or 35, I think I'd get more narrowed in. I'm thinking it's either the 285/65R20 or the 295/60R20 but not really sure.

 

To me it look like the 285 65.