King install - quick help

so....the front resi Mount is very much hitting the factory plastic, which I can cut - but what about whatever is behind it!?

 

Front right - passenger
- and I know I spelled install wrong lol

 

Those don’t fit ur truck. Send them to me immediately. I’ll even pay shipping

 

LMAO

 

cut the plastic.
have the resi in the mount prior to fitting it in(don't tight clamps too much might need to rotate if need)
then you should be able to tuck away in there.
try not to pull any or cut any of the AIP stuffs

 

Thanks! Sure seems like there isn’t any room. Must work though - 10-4.

 

Can you mount the resi on top of the platic?

 

I dont think so. cutting that little section just exposes the AIP stuff. He just needs to stuff the resi in between the mudguard and the frame

 

Screw the plastic just pop the bottom plugs and rip it out.

 

Yes, thank you!!
Trimmed up the plastic and it fit back in there. It’s definitely sitting next to whatever that tank is lol.

 

Windshield washer fluid reservoir.

 

Thanks!


So are factory sway bars ditched too?
Lmao!

 

LOL! My CNC machine is broken

 

Ditch it!

 

It’s been ditched. These Fing Kings took me just as long to do the front as it did my entire wife’s rig a few weeks back lol. These fuckers are long, heavy, and thick.

 

See I told you they didn’t work for ur truck hahah

 

LOL!
Going on the test-drive now

 

I have a serious bro-rake until I get the rear shackles in. Not sure I want to do it tonight.

 

Looks goood

 

Do it!!

 

Fawk! Did 15 Miles, front right doesn’t seem right. Almost “clunking” and it’s sitting 1” higher than driver, but adjusted the same height. I’m going to have to pull the wheel and see if I can adjust on truck.
Eta - guess it’s only 3/4” :-/

 

Check the clunking for sure. Very common to get the driver lean after lift.

 

Yea, I actually called Coach Builder and he sent me 3 CB shims, 2 for driver side 1 for passenger to account for lean. I had planned to run that setup, but after only doing 1 shim on passenger, and setting truck back down - it was pretty high. So I didn’t do 2 on driver, only one.
I’m showing 12 threads on shocks + 1 shim, which should put me at 3” - which I think I am 2.50” driver and 3.25” passenger. Passenger just doesn’t feel right. I think I’ll just adjust passenger down a bit, I don’t want to lose ride quality.