New running lights and light bar....

Thanks

 

Serious on the install time? RC site says 3-4 hours. I'm about to buy it.

 

That the way it appeared to me. I left mine and mounted a double row 32 behind it. Of course I had to remove the grille and bumper to do it. I actually think the whole center piece mesh and the sold ends might snap in. If so you could probably fit a 40 or 42. Here is mine. I like the light output of the double row but the install is a little tougher. I had the little round switches in my Tacoma but wanted something that was lit with the dash lights at night so I replaced with a switch I purchased. The round ones are easy to make. I just cut a hole in the switch blank and added the little round switch I bought at Auto Zone.

 

I had a 42" double row in my grille but it was a cheapo so I took off, will b replacing with a 30" dbl row from RC and since i have ranch hand grille gaurd RC the 42 was being blocked at ends of gg

 

Yes it took no time at all.... mounted and wired the switch in less than an hour... I have installed lots of stuff on trucks before for friends... This was by far the easiest light bar.

6 bolts total. .. two each for the brackets and one bolt each side for the light bar to the bracket... I bought this light bar used from a guy on my Houston Tundra Facebook page so I had no instructions, just, the light bar, brackets, and wire. He told me he turned the light on 4 times... This joker will light up my neighbor street. I am ready to take it out down a back country road.