1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

2006 tundra Access Cab, wiring in aftermarket radio cannot find wiring color code schematic

Discussion in '1st Gen Tundras (2000-2006)' started by tom723, Dec 17, 2017.

  1. Dec 17, 2017 at 2:22 PM
    #1
    tom723

    tom723 [OP] New Member

    Joined:
    Dec 17, 2017
    Member:
    #11572
    Messages:
    5
    Gender:
    Male
    First Name:
    Tom
    Vehicle:
    2006 Tundra SR-5 Access Cab
    I'm wiring in an aftermarket head unit in my 2006 Access Cab Tundra. The stock radio is not JBL /Fujitsu. Every color code schematic that I have looked at on the web matches up but for a handful of wires. After throwing away over $60 dollars in harness adapters that do not fit, I cut the harnesses off that went to the stock radio have all the new wires connected except for the speaker wires. I need HELP!!! Tired of riding with no stereo in the dash! I attached the wiring diagram I used but there are a couple of the speaker wire colors that don't match up. So far my new head unit powers on with ignition and illumination lights working, functions but no sound due to not knowing the right oem color code for the speakers.

    pic-2196097128782923217-1600x1200.gif
     
    Last edited: Dec 17, 2017
  2. Dec 17, 2017 at 3:33 PM
    #2
    Festerw

    Festerw New Member

    Joined:
    May 7, 2017
    Member:
    #7600
    Messages:
    3,692
    Gender:
    Male
    Cambridge Springs, PA
    Vehicle:
    04 Tundra DC
    All the charts I've seen show similar colors. The sure fire way to figure it out is to use a meter and test from each speaker.
     
    tom723[OP] likes this.
  3. Dec 17, 2017 at 4:16 PM
    #3
    tom723

    tom723 [OP] New Member

    Joined:
    Dec 17, 2017
    Member:
    #11572
    Messages:
    5
    Gender:
    Male
    First Name:
    Tom
    Vehicle:
    2006 Tundra SR-5 Access Cab
    ok, I will give that a try...will see what happens!
     
  4. Dec 18, 2017 at 6:36 AM
    #4
    GavinG83

    GavinG83 New Member

    Joined:
    Mar 28, 2017
    Member:
    #6988
    Messages:
    128
    Gender:
    Male
    First Name:
    Gavin
    Wilmington, NC
    Vehicle:
    2000 Tundra SR5
    The speaker wires are located at the factory amp under the rear passengers seat. It is signal wires at the dash location and will not give you any sound you must now bypass the amplifier and run speaker wires up to the dash.
     

Products Discussed in

To Top